Counting matching models…
I needed a thicker mounting plate for my Tripleplay pickup, so remixed this model. Pickup clips in with a decent amount of force, print is done in about 20 minutes. The thickness of the main plastic length is about 2.5mm
Remixed this case for the Helix keyboard to shrink it down a bit and allow for Choc switches, which would've been too low down on the original. Mirror the print for the right-handed part.
EDIT: Rev #2 is up, the clips now attach via a dovetail joint. Print these on their side for best results. The mount itself prints without supports without any issue and assuming your printer is dialed in moderately well the dovetails…
Made the shackle holder have a weirdly specific twist in it (which I did backwards at first, hence the two different ones in the photo) so it'd hold the shackle to the leg of my rack (with the top of the lock held by its own mount).…
So I got a headless guitar recently, that has these tuning pegs on the bridge that are just slightly too awkward to turn with your bare fingers. They have some slots cut in that allow you to turn them with a guitar pick, but most picks I…
These are all currently available results.
