Counting matching models…
Simple mobile phone holder and charging stand. There are two models to choose from: Type1 - smaller charging cable aperture with cable threaded through Type2 - open charging cable aperture You can print these models using any filament…
A model for a Katsu 65mm router dust shoe with brush attachment which fits over the end of the router to extract cuttings into a vacuum cleaner. The brush attachment needs a flat brush wrapped around it and secured with a pipe clamp…
TPLink advertise their outdoor cameras as IP65 but my experience shows that most are not as they leak through the connector ports, despite fitting their bungs. This camera shield aims to resolve this issue by blocking vertical rain…
Replacement end caps for Thule SquareBar roof bars. These are tight fit so that they don't come off again. Print using a structural filament with UV protection, like ASA or ASA-CF with at least 50% infill.
POTY Covers for QO100 dish antenna Models built based on standard JG Tech POTY with N-Type connector (unmodified) and Bullseye LNB with modified endcap Best printed using ASA or PCTG filament Assembled using rubber gasket on LNB and mount…
Moduli Elettronici (eBay seller) sells an eprom programmer called ETETRON USB Programmer V3 which is supplied without a case. This model is that of a simple case to protect the pcb components during handling but still make it possible to…
These are all currently available results.
