Counting matching models…
My powder pouring prowess is at it's lowest in the morning when I need it most. This funnel is for helping me get a powdered energy drink into a water bottle. My normal kitchen funnels extend into the water, and that causes a clog. This…
Use these to replace the bearing-l_x4 and bearing-r_x4. This model clamps the center of the 608 bearing, leaving the outer bearing free to rotate. Should be a drop-in replacement.
Trays for the smallest Apache 1800 box from Harbor Freight. ID at the bottom 8.125"x5.625"x3" (3.75" including top). Snug-fitted inserts to make custom organizers. Includes clearance for the air valve on the front. Three 1" tall trays…
Gridfinity is a great organization system with customizable bases and parts holders for any conceivable thing. I think the overriding principle is to have your parts and tools at the ready, not to store as much stuff as you can. Here I…
Added ¼" (6.35 mm) hole to attach to the base design. I used the dovetail to spot holes in the rest. In hindsight I should have threaded this part and used a set screw/grub screw instead. Print with 4-6 walls and cut threads on this side…
This is a carrier for several decks of playing cards. The inner tray comes out so you can draw from all sides. The box holds my stuff at the table so it isn't all spread out.
This tool consists of a base, an adapter to hold a part, and a peen to form the leads of a TO220 into something resembling an SMT component. The base mounts to a Panapress model 502 light assembly press. The center of the base is centered…
A stand to hold your clockwise digital caliper, with an X-acto knife and a thick 6" Mitutoyo scale.
This is a die and spacer set for trimming a radial capacitor. The die is a hardened steel plate. The included one has an array of holes on a 0.1" x 0.1" spacing. The hardened die goes next to the trimmer blade. The spacer is printed in…
Another small stand for 41 mm temperature/umidity sensor. Includes pockets to put 6 mm magnets in the base. In my case I'm going to use it on a metal shelf. The best print orientation is with the face on the build plate.
In this model I leveraged a light gridfinity base model by Doug Kremer to organize some of my Harbor Freight mini toolboxes. These boxes are probably made in several factories globally to relatively loose tolerances. The two I have here…
Only you can decide if this will improve your project. I hope it does.
These are all currently available results.
