15 models
A simple desk organizer designed to fit all the needs. With some thought out details to store a ruler and some sticky notes (77mm x 77mm or 3" x 3"). Update 2023-07-17: Added revision 2 with scalloped corners in the small parts trays.…
You need 6x “Link”, 6x “Shovel” and 2x “Spyder”. All parts screw together with M3 bolts and lock nuts. Don't tighten them to hard, the joints have to move freely. Attach a string to each Spyder parts. Thread the string from the lower…
This is a action brick clone compatible with duplo rails. If you don't have the right coloured filament try using coloured craft paper to cover the top surface. That worked surprisingly well!
Simple but effective solder fume extractor. Print instructions Additionaly to the 3D printed parts you will need: 1x Fan 80mm 1x activated charcoal filter 130mm x 130mm x 10mm 4x M3x30mm screws 8x M3x18mm screws with flat countersunk…
I needed the norm finger according to IEC 61010 specifications for pre compliance testing. Print the handle and the finger separately and glue them together. Make sure the finger is seated all the way. The final length should be 80mm. For…
Replacement tip for generation 1 TipToi pens by Ravensburger. If the tip of your TipToi pen is dented or deformed it may not work properly anymore. To fix the tip just remove the top most part of the tip until the opening is cleared…
Press this lever on the knurled part of a BNC connector. If the connectors are very tightly packed you can put the levers on backwards so the lever arms clear each other when operated.
This is a clamp that works similarly to the Hakko Omnivice. Assembly instruction: Print all four parts. When printing the base, add a pause before the hole in the center gets covered. Insert a long threaded spacer (M5 x 20 mm) with…
These parts combined form a wind/rain and sun shield for sensors to be placed outside. On the bottom you can use a cable gland (threaded M12*1.5) to secure wires leading to the inside. You need at least a cover and a base ring. To get…
Based on https://www.thingiverse.com/thing:3202882 but fixed the stability around the base. There is a weak point in the original file Print Settings Printer Brand: Prusa Printer: i3 MK3 Rafts: No Supports: No Resolution: 200 Infill: 20…
This is a collar to fit every standard 68mm diameter hole that is commonly used in the EU for installing sockets and light switches etc. If you need to feed a cable into such a hole e.g. speaker cable, HDMI, ETH to some other HiFi…
Take this G-Code and load it onto your printer to do a Cold Pull with PLA. It will automatically heat up the print head and do a slow but steady extrude while cooling down the extruder. When it reaches 90°C it will reverse the extruder…
Clip this part around the plunger of your Palmolive soap dispenser to limit the amount of soap dispensed with each stroke of the pump. Use the scaling function of your slicer to make it thicker or thinner to adjust the amount of soap…
If you don't have a cyber truck yet you can at least have some cyber truck nuts!
Pi Cam 90 degree mounting angle Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No Resolution: 0.1mm Infill: 15% Filament: Prusament PLA Galaxy black Notes: Let's you mount the CMOS module of the raspberry pi cam…
These are all currently available results.
