Counting matching models…
Deburr tool that takes standard 1/8" [3.2mm] deburring blades. These are a common tool for machinists, but work well to clean up bottom edges of prints, especially if you have to use a brim. The two inserts snap into the holes and act as…
Before printing , make sure you have an Intex 29054 telescopic rod and not an Intex 29055. You can edit the source fusion 360 file for 29055.
Adapter for connecting the pool vacuum cleaner to the sump pump. Use brim, no supports needed. If you print from ABS you need to specify a scale of 102% to compensate for shrinkage. tpu_ring.stl print from TPU or find a suitable rubber…
I printed a Fly Swatter Gun Card out of PETG, the spring came out strong, but the grid on the arrow cracked after the second shot. So I printed a TPU grid to repair the arrow. To repair it, you need to cut off the rest of the grid with…
This is a remix addon for ltlowe Makita 18v adapter 52x58x3 . You need print his model first. No need supports, PETG, 20% infill 0.2 layer, 5 perimiters or use custom 100% infill in clip section. also need 4 3x10 mm screws, jack with wire.
It can generate much stringing when print, if it is then check you process settings: retraction, temperture, speed. I printed only sample of fasteners not box - its work fine. I add fusion 360 file so you can modify it.
This is a model optimized for 3D printing, 245 and 205 mm sawblade compartments, the depth has been increased by 5 mm to store tall sawblades For greater durability of the hinges and latch attachment in the slicer, you can add modifiers…
modeled my version of the handle for greater durability and ease of printing without supports.
The original plastic part has a large backlash and is attached by self-tapping screw, which also over time loosens. There are two holes on the steering wheel to attach the plastic part, the regular one is attached only at the bottom. The…
To replace a broken button.
Стесались грани у соединительной муфты - запустили блендер не защелкнув поворотный фиксатор. Смоделировал замену. Если будете печатать из нейлона учтите усадку, для моего нейлона нужно было отмасштабировать до 102.6% по всем осям. По Z…
from center to edge increase per layer - 0.2, 0.4, 0.6, 0.8
These are all currently available results.
