Counting matching models…
The purpose of these modifications was to reduce the angle of the overhangs on the bellows segments and also make the walls very thin to help with tearing due to the material stressing itself. It also has the added benefit of moving more…
A simple tool to make opening and closing PVC glue lids easier. It also gives you a bigger surface to handle the brush. Just press on the lid as straight as possible until it won't budge anymore. Then you can easily open the lid if it's…
KZ ZS10 Pro 2 Wrap Case Remix that adds a slot on the underside for the 3.5mm tip: https://www.thingiverse.com/thing:6728938 Print Settings: Layer Height: 0.2mm Material: PETG Supports: None
Replaces the spring and blade retention pin with a self retaining spring and a larger base pin, also adds one more locking lobe so the spring doesn't get squished. Print Settings: Layer Height: 0.2mm Infill: 30% Material: PETG Supports on…
This is a remix of the LTT Screwdriver Bit Holder (Multiple Sizes) that allows using standard sized bits. I had a normal bit set that you can buy anywhere and I needed a nice case to put it in. I used the LTT Screwdriver Bit Holder…
A simple compact dispenser for utility blades. Includes a pusher or lid depending on which you prefer. Print Settings: Material: PETG Infill: 15% Perimeters: 2 Supports: Build plate only for the blade exit slot
I recently bought a stihl chainsaw and would sometimes have trouble opening the Gas and Chain Oil caps because they were slippery. This tool gives you more leverage when opening or tightening the caps. Print at 100% infill and use two M3…
This is a simple clip designed to hold the hood prop rod for a 2003 Chevy Venture. Material: PLA (but should use something more heat resistant since it's in the engine bay) Infill: 100% Supports: Yes, on both the top and bottom clip on…
Tool to remove the top of a Rainbird 5000 sprinkler Print Settings: Material: PETG Infill: 15% Perimeters: 4
Flow restrictor for Delta shower heads with diverter. It fits inside the part that screws onto the shower pipe that comes out of the wall. Print Settings: Material: PETG Perimeters: 6 Infill: 100%
Replacement gas cap for the Toro 20321 mower (Part Number: 55-3575). It used the internal parts from the original gas cap. Instructions: Material: PETG (PLA will degrade over time with gasoline exposure) Nozzle: 0.4mm Layer Height: 0.15mm…
Replacement part for the sliding part in the center vent. The whole vent section on the Forester can be popped out by using a screwdriver to pop up the clips above the screen, on the sides and and below the vents. Once popped out you can…
This replaces the old thrust bearing shaft that has a captive bearing. It will accept a standard skate bearing and will fit in the same hole for the blade guide. Printing Instructions: You can print this in the orientation provided in the…
I designed a snap in cover that protect a drip irrigation straight splices. These work with RainBird brown 1/2 drip tubing straight splices. The purpose for creating these was that I keep breaking these with a string trimmer when there…
A minimalistic tamping base for the IKAPE 54mm Bottomless Portafilter. Printing Instructions: Layer Height: 0.2mm Perimeters: 3-4 Infill: 15%
This allows replacing the smaller wand with a larger model version. The new holder press fits into the groove for the old one. I used this one: https://www.amazon.com/dp/B0BRSL99MW It's supposed to be for larger models but it works on the…
These are all currently available results.
