All models

Counting matching models…

1515 Makerbeam extrusion cable cover / cable clip

This was created by jakoob of the Voron discord and uploaded with permission.

Downloads: 159
Likes: 23
Rating: 0

Heavy Duty Center Insulator for G5RV or ZS6BKW Antenna

This is a heavy duty center Insulator for a G5RV or ZS6BKW antenna. It follows a common design to other models I have seen but it is much thicker and reinforced. I printed this in ASA, since this needs to have some strength and survive…

Downloads: 139
Likes: 11
Rating: 5

Order a print of this model

PrintablesPoisson

Honeycomb Wall Holder for Flashlight

Remixed flashlight holder for larger flashlight

Downloads: 122
Likes: 10
Rating: 5

Order a print of this model

PrintablesPoisson

Raspberry PI CM4 antenna mount for Salad Fork

The tolerances are very tight. You may need to file out the inner circle of the mount for the antenna to fit in, and it will need more than hand force to pop it into the skirts. I recommend pliers. I designed this around the Salad Fork…

Downloads: 40
Likes: 6
Rating: 5

Order a print of this model

PrintablesPoisson

Wolf River Coil Mega Tripod Foot

Even with the mega tripod that Wolf River Coils offers for their antenna, it can still blow over in the wind. I made these feet that slide onto the end of the tripod legs with a small hole for a metal tent peg to drive into the ground.…

Downloads: 36
Likes: 10
Rating: 0

Order a print of this model

PrintablesPoisson

Yagi brackets for 1/4" aluminum elements to mount to round booms

I initially used the scad files at the thingiverse link to generate brackets close to the size I needed for the aluminum element diameter, and round boom diameter to clamp them too. If you want to do this just download openscad and do it…

Downloads: 33
Likes: 4
Rating: 0

Order a print of this model

PrintablesPoisson

PTFE tube mount for Salad Fork

This is to go with the side mount spool holder for the Salad Fork, spacing is designed the same as the model below and is designed for use with the Fabreeko Salad Fork kit. https://www.printables.com/model/362442-remix-for-the-salad-fork

Downloads: 22
Likes: 7
Rating: 0

Order a print of this model

PrintablesPoisson

Carbon fiber yagi boom connector satran mount

This replaces the boom connector on the Carbon arrow yagi, the part that connects the two ends of the carbon fiber tubes. It adds a mount for the Satran and turns the element to be at a 45 degree angle. Mount the rest of the elements to…

Downloads: 18
Likes: 5
Rating: 0

Order a print of this model

PrintablesPoisson

SO-239 rain/dust cover

Printed out of TPU. 10% infill 3 perimeters and 3 top and bottom layers. Needs supports. Meant for putting over an open SO-239 connector when it is outdoors to keep off the elements.

Downloads: 14
Likes: 0
Rating: 0

Order a print of this model

These are all currently available results.