Counting matching models…
Boondocking with a RV and filling the water tank with water bottle was a challange. I found this RV water cap thingiverse.com/thing:2438303 that led me to create a water funnel printables.com/model/334105-rv-water-spout. It worked great…
My wife wanted a me to make her a yarn gauge so this is what I came out with Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Infill: 25% Filament: Overture PLA Category: Gadgets
ANL Fuse holder to match my 364396-buss-bar. I used ¼ X 20 stainless bolts I printed in PLA with 20% infill
This is a 5 lug buss-bar with protective cover. I used 1/4 by 20 stainless bolts and a ¾ inch aluminum flat bar, I droped some red paint in the groove to make the wording more apparent. I printed in PLA and made the walls, top and bottom…
Camping in a windy are I have broken 2 of the door latches that keeps the door open so I created a much beefier one. V1 is a strait model V2 has a slight bed to accommodate the angle between the door and the RV wall
I started with a badge/ logo from Ryszard Poplavskij and remixed it to 200mm diameter and created 4 files so I could print a crisp colour 3d print with my Ender3V2 Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No…
New Zumo XT Mount, I created this Zumo XT mount for my 2005 GL1800. My eyes don't have to drift very far to see the GPS. It is secured with 2 way tape , so easy to remove without a trace. The only downside is that it obscures the turn…
I lost my knob for my Gerbing motorcycle heated vest controller. It has a 6mm hole for the shaft and 19 mm wide and 19mm tall
This adapts a 92 mm 9225 muffin fan to a 2" plastic pipe. Using 2 of these enables you to insert a fan in a 2" pipe run. I am using it to exhaust fumes from my composting toilet in our RV.
This is a cover for a 50L ARB Fridge Freezer display. It may fit other ARB fridge display however I have not tried . When I go camping and the ARB is sitting outside at night, the display gives off a lot of light and can attract the…
RV antenna coax outside entry with cap. I was camped on the beach next to the gulf and the salt water destroid my coax connector because the antenna was powered. It is larger that the RV original. I recommend printing the cap 1 or 2%…
Needed a cell phone holder that would rest on my laptop. Used the upper portion of a selfie stick and created the base
I created this simple support and screwed in a 1/4" by 20 bolt and used 3m double sided tape. The binoculars are away from the wall and can swing but not touch the wall of or RV when on the move
This extends the spool holder to avoid collision with the Z motor when inserting and removing the spool Category: 3D Printer Accessories
These are all currently available results.
