Counting matching models…
As of now, the (Un)original Dryer D2 is available. It is an improved version of this drybox, with many new features. Now supporting modular heating, filament weighing, and is much easier to assemble! Check it out here: The (Un)original…
As of now, the (Un)original Dryer D2 is available. It is an improved version of this drybox, with many new features. Now supporting modular heating, filament weighing, and is much easier to assemble! Check it out here: Disclaimer: This…
Update 12-10-2026: After receiving feedback that people wanted to see pictures of the actual dryer and not just renders, I now added some pictures of my prototype! * Including heater, the base dryer without heater is ~660g ** RFID spool…
I used a buckle clip style design to make the model collapsible. (see third image) The flames are designed to be friction fit but I also used a small amount of glue just to be sure. Print settings: I printed all parts with 0.2mm…
About The espCam is an enclosure for the ESP32 CAM microcontroller. The camera is designed to be a small good looking security camera that can also be used to monitor prints. It features a ring light with diffuser that is an improvement…
Supports are required for both parts. I printed the stem both upsidedown and in the normal orientation. I prefer the end result of the upsidedown print, however it was a little harder to remove the supports. I ended up using 15% infill…
Update: The base has been made higher resolution than shown in the picture All parts except for the shell can be printed without supports. I used 1.5-2.0mm layerheight depending on the overall printtime. I also used a little bit of glue…
About: This 45 record adapter represents a band. It features a fender electric guitar, a microphone and a speaker, each visible from a different side. Feel free to remix and make different instruments or post a make! Print instructions: -…
This secret easter egg is perfect for storing your chocolate eggs. It is 12.3 cm tall and a little under 10 cm in diameter. It uses 12 5*2mm round neodymium magnets to attach the two parts (6 for each side). Print Instructions: Start…
Harry Styles themed 45 record adapter. inspired by his song Watermelon Sugar. This model is capable of housing a 1.8 cm (0.7 inch) tall pin. Print instructions: - For the base of the model I made two versions, one with no tolerances and a…
AAAA battery holder in magazine style, spring-fed, capable of holding +/-10 AAAA batteries.
These are all currently available results.
