Counting matching models…
The original model is entirely glued together, this fulfills a request to make one end of the axle threaded so it can be easily disassembled to refill or replace the pod. Use all other parts (including one axle cap still glued) from the…
Plugs the arbor hole that spews dust everywhere. This is a loose fit meant for easy install and removal: 1. Insert the tab on the left. 2. Line up the tabs on the top and bottom. 3. Mallet time! (on the right) Print in PETG so it'll be…
Wires broke on my QIDI X-Plus 3's parts blower, which is a non-standard 5015 blower that's hard (or impossible to find). The original duct requires cutting to fit a Winsinn 5015 blower but the giant hole causes pressure loss. Print in…
Tobias Funke's famous license plate from Arrested Development. California script: https://kberkery.com/free-vector-license-plate-script/ Font: https://www.fontzillion.com/fonts/ruweshed/penitentiary-gothic-fill I didn't do a good job of…
This remix fixes the End piece so screws are more accessible, see original model for Front piece and print instructions.
Replace the countersunk screw holes with a small recessed square that'll fit 3M double-sided foam tape in case you want to make adjustments in the future.
Heatset inserts (M3 thread, 4mm length, 4.5mm outer diameter, 3.9mm nub)https://www.aliexpress.us/item/3256805034317562.html M3x10mm button head screw See original model for printing instructions. You probably want extra walls so there's…
Adapts the original plunger on the GP Enmotion Impulse Automated Touchless Paper Towel Dispenser to work with cheaper rolls with a smaller inner-radius like (Scott 04142 02). The model is provided at 95% of the original roll size but this…
According to Nero3D, mounting with screws instead of the provided blue tack provides a slightly more accurate measurement. This also allows mounting to the gantry instead of the shroud. Use M2 screws/nuts to mount the PCB. Use M3 screws…
Replacement for a broken knob on Kenmore range hood. Print with supports. Note: I used 101.5% shrinkage compensation for PLA, adjust accordingly if dimensions slightly off.
Connect a JST extension cable to the unused fan port on the motherboard, then connect the fan to that extension (for easy removal): https://github.com/Guilouz/Creality-K1-and-K1-Max/wiki/Boards-Layout To hold the filter, from the other…
The hole is 3.7mm wide by 4.6mm deep. Make sure your inserts are about 1mm wider than the hole (so there's plastic to grip) and not as deep.
Cable grommet in 3 pieces for a ¾" (nominal) desktop with 1 ¾" diameter hole: * PETG core for flexibility in insertion and locking into table * TPU gasket to avoid marring the table top * TPU cap with slots for 3 power cables and 3 USB…
These are all currently available results.
