Counting matching models…
Přítelkyně mě požádala o lopatku pro dávkování krmení jejím milovaným hlodavcům a tak mne napadl, když se blíží ten Valentýn, tento motiv. My girlfried asked me for a feeding shovel she could feed her beloved pets with and because is the…
This model is very easy to print. It was made out of three parts, that had to be glued together. I used PLA filament, PLA can be easily bonded with CA glues. Orientation on print bed as seen on the picture above. Supports are in this case…
I bought two of these nice torches and both of them suffered from a broken battery holder, they simply fell apart over a short period of time. This holder is, as the original one, made out of two parts, i used the original screws to fix…
I bought a smart weatherstation and the sensor comes only with a strap to hang it up somewhere. There persists problems with curling due to overhangs on both sides, so i experimented with speed., temp. and other settings, but in the end i…
Rychle a jednoduše se tiskne. Vytiskl jsem z PLA, při výšce 0,1 mm, doba tisku ca. 20 minut. Pro lepší fixaci doporučuji kapku lepidla. Fast and easy to print. I printed it in PLA with a 0,1 layer height, it took about 20 minutes. Use a…
But it also fits approx. 4m of 1mm solder wire very well. You will just need 3pcs of 3mm woodscrews, with a thread length of up to 8mm, i used screws with 6mm long threads. Countersunk or flat head screws, it depends on your preference…
These are all currently available results.
