Counting matching models…
An extuder motor indicator made from a 3D Printable Jet Engine's fan by CATIAV5FTW - scaled down to 25%, with a cone or without. Link to this awesome printable jet engine here: Thingiverse There are three versions: With an integrated cone…
This is a reverse engineered Prusa MMU2 idler with a few changes. As I've cracked 2 of the original ones and had some issues with idler bearings being a little too loose, I've drawn this in Fusion basing on original. Fit and size are the…
Update 1: I've updated the base a little - made the filament channel wider and added a chamfer on the entrance TNDave was kind enough to let me modify his awesome design, so I've made a fully printable version (you don't need the acrylic…
These are the boxes for Kaufland/Lidl wall organizers. They are roughly in the dimensions of original boxes, but my goal was not to replicate them and make them stackable, but to replace/print more of the chosen size. Thus, they are not…
This is quickly prepared in Fusion 360 to have any print cooling on my MK2.5S with Volcano hotend. It's not optimized or flow-tested in any way, I pretty much just roughly extended the stock shroud. Use ABS or similar high-temp plastic…
This is a simple cap for M8 nut holding the windshield wiper arm. The print needs supports and I recommend using ASA or other high-temp and elements-resistant plastic. I've designed it for Skoda Octavia II (1Z), but should be pretty…
Useful when changing idler tension often, e.g. when you switch between rigid and flexible filaments. The channel might push on the heater cable a bit, but should not cause any major strain. It is angled (narrow opening hole and wider…
Low-profile gas meter / triangle key used in some European countries that you can have on a keyring.
No more fiddling with the spool holder that expands and retracts accidentally with a spool. Dimensions are roughly the same as stock. Uses the same hardware, i.e. M5x85 bolt used in the early versions of the XL (with a printed spool…
This is a 2-part glue gun stand . I designed it to hold the FMGG6996 (TY-G6006) 80W glue gun, which I bought in Kaufland , but I think Lidl had the similar sized ones. The gun's front part, which goes in the stand is 30x46 mm, and the…
Allows “one-finger” scrolling and pressing. Print as oriented. Contains a sacrificial support that you must break away before pressing onto the LCD encoder shaft.
A simple holder for a Somfy Keytis garage door/gate remote. Although modeled around the Keytis 4 NTS (4-channel), holds the Keytis 2 NS as well. The smaller remote is just a bit more loose, but does not fall out on itself. Hole size is 4…
The mechanical ventilation system installed during renovation of my house needs to have a flow of air between rooms. It is usually realized by cutting out a 200 cm² opening near the bottom edge to let the air pass. I did not want a…
These are all currently available results.
