Counting matching models…
Simple insert with an open cone allowing you to seal vacuum storage bags with a Shark stick vacuum. I have model number IZ142 26. Printed in PLA with a brim. I have to pull the max power trigger for it to work with the suction ports on…
The cat door did not come with anything to cover the space between the front and back pieces, leaving an ugly view of my hollow door. It is sized for a 22mm gap, the parametric model is included so you can resize or remix. The flat brim…
Designed for my lawnmower but usable on a bike or anywhere else you want to strap it. Printed in PETG with 5 perimeters and 40% infill. Velcro strap is recommended for most uses, especially if you expect it to jostle around. The models…
Simple corner wall mount for the SimpliSafe base station. Looks good when paired with a cord cover. Printed with PLA at a 0.2mm layer height, tree supports on the build plate, and a brim.
Corner wall mount for the Linksys Velop WHW01 mesh router. Printed with PLA at a 0.2mm layer height, tree supports on build plate, and a brim and it came out clean. Combining with some cord covers from the hardware store gave a clean look…
TPU phone case for the iPhone 12. I uploaded two versions, one of which has a slot for a Magsafe magnet I took from my broken Otterbox case. I printed using Cura slicer since Prusaslicer didn't have a TPU preset. I printed with supports…
Simple adapter that allows you to use the closet rods from the ShelfTrack kit on a regular wire shelf. It fits snug and has held up in my closet for 10 months now without issues. Printed in PLA, 0.2mm layer height.
Simple gasket for a Craftsman mower gas cap. I borrowed the mower from a friend so I'm not sure what the original looked like. Printed with Overture 95A TPU with 0.2mm layer lines inner diameter = 46mm outer diameter = 54mm thickness = 3mm
The case was designed using the iPhone 17 Pro design specs for a clean fit. The edges have a cupped "crumple zone" which should give it good fall protection while staying slim. The top lip works with a glass screen protector. I printed it…
End cap for bicycle drop bars printed in PETG. Mine have been in use for almost a year and a half without any issues.
Designed to hold internally routed cables in place and cover the entry port. It is angled so the cable is protected from the sharp edges of the port. It is sized for shift cable housing (4mm) but I included the F360 model so you can…
I was looking for an unobtrusive way to elevate my dogs food bowl and came up with this. I printed it on it's side in PLA at 0.2 mm layer height. It's been in use for almost 9 months and is still working great. I've only noticed a small…
Replacement spray angle adjuster (part 4 in diagram) for the Graco 2900 Paint Sprayer. This same sprayer is also sold as the Earlex HV2901 / HV2900. I printed in PETG with supports on the inside. I designed this for a friend of a…
The case was designed using the iPhone 16 design specs for a clean fit. The edges have a cupped "crumple zone" which should give it good fall protection while staying slim. The top lip works with a glass screen protector. I printed it…
This tool head is shaped to slide over all standard pallet slats and works with the flexible dryer vent cleaning rods I already have. Designed to print with no supports. I printed in black Overture PETG, 0.2mm layer height. It uses M6x0.8…
These are all currently available results.
