Counting matching models…
My old ledger nano s developed a crack on one corner, near the screen, so I decided to make a printable replacement. I've tested it with the OEM parts (other than a replacement screen) and it functions normally. Some sanding may be needed…
Printed in Prusament PLA. If you want a tighter fit for the camera holder dowel pin, wrapping with a few layers of scotch tape works well. edit 05/02/2025 - updated lid and case to fix position of camera ribbon slot, add cut-out for…
This holder will allow you to use the metal clip that you find on most standard garage door opener fobs to hold a Zooz ZEN34 z-wave switch to your car's sun visor. You can associate the switch with e.g. the Zooz ZEN17 universal relay…
I created this as a project to make an aliens-style sentry gun out of an x-shot insanity nerf blaster. This setup provides azimuth control only, elevation is fixed. The control panel is intended to mount directly to the picatinny rail and…
This is a box that slips over an Anker 511 USB charger and is intended to hold the electronics for a minimal ESPHome analog sensor reader using the M5Stack NanoC6 ESP32C6-based MCU and the ADS1110-based ADC module. I have included build…
A drop-in replacement for the cabinet door hinges that come with Ikea FJÄLLBO shelves / TV stands, part number 153334. I had to make this because I have a fjallbo shelving unit that I never put the doors on, I lost the original hardware,…
This is a 1mm-thick spacer / gasket that fits on the lid of the 10 x 3ml box . I created it because the magnets I have are just slightly too tall for the original model and there is a small gap between the lid and the box with them…
These are all currently available results.
