Counting matching models…
toothbrush holder. Print in place. Snaps closed. There are two sizes. large 1, small 2 with the same pivot gap. The GAP on print in place often can't be scaled. When you scale a file it also scales the gap. Depending on the details of…
I tried others. and it popped open when I tried to take it out of the AMS. The box is open on the large size for easy loading. This makes it not stand up when loading desiccant. I hold the box when loading. Prints without support. The…
a remix of a similar box from Collinsb. I enlarged strengthening the tab for opening. The cover was getting stuck on the divider walls. added a few corner fillets. It has worked fine for me out of standard PLA. there are 3 parts. the main…
This is an example of an iris done in SW intended to be 3d printed. You will need to reorent the STL files to not need support. The render of the assy is not showing the twisting that the leafs need in reality. the Pins need to be glued…
a set of 6 rollers to store cables. Minimizing space needed. two parts that snap together. put the midpoint of cable in center, snap together, then spin one side to wind up. Just pull to unwind. shape of center post minimizes sharp bend…
a second version of the iris. This one is thinner and has no external bumps for the screws that hold it together. Some hints about assembly. The layering of the leaves needs some smoothing. In particular the inner and outer edges need to…
the boxes I had tried with top access are problematic. the top can easily come off. and spill the desiccant beads in the AMS. I had a snap in rear entry, but sometime it failed. So I made a slide in version that will not fail. allowing…
fits in the cup holder and fits a larger cup. depending on your printer details it could not use support. the middle section is supported on ends, friendly to bridging. this surface is rairly seen. So cleanup remnants, or bridge remnants…
Split your bins into smaller storage bins. This model is for a double. Single sub-divider. Other models divide into 1 and 4. Features: no support needed to print. stack on other units place for labels Bump on bottom helps pick up things…
Split your bins into smaller storage bins. This model is for a 4 bins. Other models divide into 1 and 2. Features: no support needed to print. stack on other units place for labels Bump on bottom helps pick up things like flat washers.
A holder for an “echo dot” that hangs on the USB adapter. Designed to fit a 30mm x 22mm (1.2in x .85in). Will print with very little support that is in a easy to remove area (the cable to the Dot).
The track is intended for 3 parts. two are glued together making the base. The reason they are glued together and not just printed from the base is so the weak part of the part (the fingers sticking up are not weaker because of print…
Split your bins into smaller storage bins. This model is for a single. No sub-divider. Other models divide into 2 and 4. Features: no support needed to print. stack on other units place for labels Bump on bottom helps pick up things like…
I use blueray for my long term storage. I have a lot of disks that I wanted in the same box. these two parts can be printed without any support needed. To support the center post there is a hole intended to put a standard 3/8 dia dowel in…
Could print it out of a verity materials. If you are printing it from a soft material the thick version. 4 in wide face. Included are the Solidworks files, so you can change the file parametrically. This is a use that you might choose to…
I used some double sided tape to stick this to the bottom of the toilets seat.
bamboo labs nozzle box that snaps together, and interlocks with stack. Hole in cover to see the size of the nozzle inside. with nothing holding the nozzle in, no need for finger grab. just turn the box upside down.
These are all currently available results.
