Counting matching models…
I would recommend using supports, and also to use variable layer height especially on the top part as this would need more detail to come out better. This is already done on the .3mf file attached.
All of them print without supports apart from the knight which requires a tiny amount of support material (organic obviously) on the nose. To do this you will have to enable supports, use the paint on supports feature to paint supports on…
There are 2 GCODEs included. One of them irons the top of the print to give it a smooth and gapless finish, but it is almost 25 minutes longer…
Print the parts and then use a small length of filament to make the hinge. This way the hinge is a lot stronger and doesn’t break as easily as some of the other models I’ve tested. I would recommend printing at a 0.2mm layer height with 3…
This cap hanger has a 20 mm gap for the shelf and in the first image, the 2 hangers on the left are V2 while the one on the right is V1. in order to prevent them sliding around on the shelved I would recommend using a tiny bit of blutack…
Simple model to hold the iPad ergonomically when using it as a second display. This is printed sideways and can be printed with supports to improve the quality of the bridges. I used some sandpaper and a heatgun to smooth out the top of…
The model is fully 3D printed (no extra parts required) and the lid and box should just snap together, although this took quite a bit of work from me and a little bit of lost material, but this ensured the hinge was as strong as possible.…
It should work with all phones that are less than 12mm thick, including the newest iPhone (14 Pro Max)
add a brim to prevent the print failing as there is very little contact with the baseplate
it can be 3D printed or laser cut (dxf attached)
Simple laptop stand for Mac. The thickness between both sides of the stand is 12.5 mm so it may fit other laptops too. There are also 4 holes on the bottom for inserting rubber feet so the stand doesn’t slide around.
A 2 part holder to hold your sticky notes or other pieces of paper firmly on your cork board so that they are more easily accessible. The 2 part design allows the width of the holder to be altered to however small or large is necessary so…
A simple holder for your pushpins. There are 5 holes at the top to use to make it as secure as you want (only 2 are used in the picture) and there are a further 2 holes at the bottom in the pushpin area to secure the bottom of the box too…
requires 2 4x15mm magnets and a print pause when the magnets are inserted. Be sure to make sure they are inserted in the correct orientations.
A simple coaster of ganesh, and there are options to have the design raised or embossed. doing a colour change on the raised design would make it look a lot better
the flat shelves can be printed with the shelf face to the ground (though be careful of the print lifting off the bed, so I would recommend cleaning the bed and maybe using a brim) and the raised edge shelved need to be printed with the…
These are all currently available results.
