Counting matching models…
This is a quick print 1/64 scale drive on car lift. Unfortunately the lift doesn't go up and down, but instead is stationary in a position the works great for Macro photos of your favorite diecast cars. Prints in two pieces, and you can…
Looking for a fun board game to kill some time? Look no further, Quoridor is a two- or four-player intuitive strategy game. Quoridor received the Mensa Mind Game award in 1997 and the Game Of The Year in the United States, France, Canada…
I've wanted to create a chess set for a while, and decided to design one from scratch. This 16"x16" board prints in 4 pieces with a single circular connector in the center. The chess pieces just need supports for the knights due to the…
This is a super quick design to test the ability of a printer to complete a 190mm bridge without the middle sagging to the bottom. This is also a good benchmark for bed temperature, incorrect bed temperature will cause the bridge to sag,…
A fun gameboy screenshot created in HueForge 200mm x 180mm fits on most printers! As seen on tiktok @extrudedhappiness Print at 100% infill with a layer height of 0.16mm with a base layer of 0.2mm Swap Instructions: (Use height range…
After finding a cheap 24 pack of flickering LED tea lights online, I wanted to design a holder that could print in two pieces that would look nice on a table. Printed with a .4mm nozzle, at .2mm layer height. The insert should be printed…
These are all currently available results.
