Counting matching models…
I came up with this after getting my fork back from the shop for a rebuild. the cap covering the rebound knobs was put on a little too tightly, and was covered in oil from the service, making it nearly impossible to get off, which is why…
Bike bar end for flat bars, so this model should work for MTB, BMX, and commuter bikes. the model was designed to fit chromag 31.8 fubars, it should work for most other models of bars, but it may be looser in other models. I have included…
This is a Presta valve cap with proper #10 24tpi threading to fit the valve better than other models out there. it included a filleted square hole for removing the valve core on Presta valves. I find Presta valve tools to be small, and…
I wanted to print some Presta valve caps. Unfortunately a lot of the existing models I could find needed weird scaling for the threads to work. I modelled these with the proper #12, 24 tpi found on the Presta valve core. I made a few…
I wasn't happy with either the looks, or airflow of my DeepCool CC360 PC case, so I designed this replacement. No glue, or screws are required for assembly. The front plate is made of 2 halves. Each of which is made of a 3 piece…
This is a simple 18m high wrist rest I designed to fit my Keychron V1, however, it should work well with any 75% or ten-keyless layout keyboard. I designed this wrist rest to have a more squared-profile, so your wrists sit higher relative…
This is a simple cover for front deraileur direct mounts. after converting an older bike to a 1x drivetrain, I wanted something to cover the raw aluminum, this is what I came up with. To intall. match up the slot with the matching one on…
I designed this lower chain guide to clip onto your existing OneUp Components bashguard, this chain guide is a sleek and effective addition to your bike. It mounts easily by replacing the bolt retention clip on your OneUp bash guard. I…
These are all currently available results.
