Counting matching models…
Nozzle scrubber for Voron 2.4 I was having issues with oozing with my Revo Hot End and it was throwing off the Z Calibration plugin. So I designed this with parts I had to hand. Works a treat! BOM: Silicone Egg Ring - 2.5mm thick -…
Just a quick modification of an existing design to add extra length on the strain relief to enable it to be used for the Nitehawk36
Remix of https://www.printables.com/model/569384-radiomaster-pocket-gimbal-protection - Designed from the ground up using dimensions taken from the STL in Orca Slicer. Remix features larger Stick holes (10mm) for custom Sticks and a…
I needed a small parts bin for all the fixings I've accumulated, so an hour in CAD and this is the result. Printing Notes: This is designed to be printed at 0.4mm extrusion width with a 0.4mm nozzle. You may find that higher extrusion…
I couldn't find a decent filament cutter that used a Stanley knife blade so half and hour in CAD and I knocked this up. Has guides for 45° and Straight cuts, can be used left or right handed. Uses a Stanley No. 1992 Type blade. Has holes…
I'm not a fan of screwing into plastic or sacrificial layers on holes. So I've updated the parts that would use these to use cross hatch bridging on holes that would use a sacrificial layer and where the bolt would screw into plastic, I…
A quick design for an ESPHome Temperature Sensor. If the ESP board does not seat properly, make sure the edges are filed flush.
Printable Cable Raceway/Trunking for cable management - Limited Sizes, but should a specific size be needed, drop a comment here and I will size and upload.
A quick Case for an ESP32 C3 and DHT-11 with an LED . Everything should just press fit in and together, tolerances are tight. If things are loose a little hot glue goes a long way. 05/12/25 - Tightened the tolerance on the lid, it should…
Printable IKEA Skådis - 320mm x 320mm - Requires a large (350mm²) printer, built in stand-offs, this is the same pitch slot pattern as the original Skådis so all accessories should work.
A Basic nozzle scrubber for a Voron 2.4 using the now ubiquitous A1 Mini Silicone Scrubber. Fixes in place with 2 M3 T-Nuts and M3x8 SHCS.
Poop bucket for use with a MMU system such as the Box Turtle or Night Owl. Has a cut out for use with our Silicone Nozzle Scrubber Built in support in wire clearance arch will need removing before use. NOTE: Due to size constraints, this…
I wanted a PiTFT43 case, but none suited my use case. Fizzystech's case was the closest so I took inspiration from that.
I needed a mount for the Runcam 5 Orange and tried the Foxeer Box 2 mount but it was too big, so an hour in CAD and this is the result. 25 degree up-tilt.
I didn't need the 2nd (lower) filament sensor, so I've edited the CAD to remove it and added 2 access holes to allow for fixing the switch in place.
Redesign of my GEPRC Runcam 5 Mount to fit the Martian 2 Anniversary Edition frame. 25 Degree up-tilt. Print as orientated, supports recommended, but the holes can be bridged.
A mount for WS2182 Style LED Strip/Tape to be mounted into a corner of a room. Up to 10mm wide strip can be used. Infinitely expandable by scaling the 50mm section and Diffuser to your required size in your preferred slicer. All parts are…
58mm Coffee Tamper in 3 parts, shaft to be printed in Woodfill
These are all currently available results.
