Counting matching models…
I decided to create my own water pump using a 775 motor I had lying around. It is capable of some pretty hefty flow depending on how big you make the body and impeller. If you find that your motor is overheating, lower the height of the…
This is meant to be used with USB-A male connectors and 30AWG 4CORE wire/cable. For best fitment print in vertical orientation. Pour some hot glue inside the cover before pushing the connector inside to secure it.
This case is meant to be used with a picoPSU or any clone of it. It features an 8mm hole on the back for the power input port of the picoPSU, as well as a 12mm hole for a vandal power switch. It also features VESA-75 and VESA-100 mounting…
This bracket allows the user to mount 2 noctua NF-A9x14 fans with 8 M3x16 screws to make the GPU a lot quieter. I also suggest removing the backplate as it does not cool anything, but rather hinder cooling. Please note that this mod…
This is a simple 14mm CCW thread adapter for the Cyma CM.127 AEP. The CM.127 has a glued piece of plastic at the end of the barrel where a 14mm CCW thread “should've” been. As such, I modeled this thread adapter with an extra cover piece…
I was pretty annoyed that my routed cables were being squished between my table and the printer frame. That's why I designed these extenders for the rubber feet in order to elevate the printer by 28mm so as to no longer squish my routed…
I decided to create my own rechargeable electric screwdriver as I did not like the existing models on the internet or in stores. This one features a battery protection circuit, sliding actuator, a 4.4Wh battery, and a 1:200 reductor…
Was getting tired of all the electromagnetic interference my USB microphones picked up, so I did some research and figured out that electret capsules are not affected by it (not as much). Having said that, I designed my own “enclosure”…
Tighter tolerances for the 8mm rods so they stop “singing” when the extruder carriage moves up/down.
This is an adapter for RJ45 Keystone sockets that can be screwed into panels from the back.
The case measures 25x20x9cm for a total volume of 4.5 liters. It supports coolers up to 70mm in height, and low profile GPUs with a total length of 185mm. This case is meant to be used with a HDPLEX 250W GaN PSU or picoPSU or any clone of…
I was annoyed that this wonderful headset would not fit my head, so I designed an adaptor to rectify the problem. It comes in 2 parts: a body, and a latch. The latch is there to prevent the cups from sliding off the adaptor body. It goes…
A simple screw for airsoft AR-15 style replicas that have a wobbly stock. Most airsoft AR-15 replicas have stocks that wobble a little bit; most of them also ship with stocks compatible with crane style batteries which feature a hole at…
This shroud is meant to enable compatibility of the Asus ROG Strix B760I-Gaming WiFi motherboard with the Noctua NH-L12S cooler which features a 120mm fan (unlike the NH-L12 Ghost S1). The shroud must be printed with the side facing the…
This is a simple case for the FYSETC SD-WIFI adapter which allows a Micro SD Card to be accessed over wifi while being used.
These are all currently available results.
