Counting matching models…
This is a model of a the Valorant knife Reaver. Simple to print and scalable. I printed with PLA no supports needed (one side is flat for printing) Leave a like please it makes me so happy :)
Quick, fun print for a kid or someone who likes the avatar or gliders. Less than 30 min print time! Ik it looks silly with the front that way but I wanted it to be fully 3d printed. Make sure you have a good first layer! -90% infill (this…
I printed it in pla at 60% scale factor and only used supports for the chamber The included blocks are studs for the square holes in the back so you can snap it together or you can just glue it
I printed at .16 layer height and scaled it down to 60% but would be much better printed at 100% the mechanism in the trigger is held by tension so make sure u put the grabbing part in the correct way or it will just not hold it.
Simple and quick bed leveling model that should be printed at .2mm layer height I used 5 perimeters so i wouldnt get the infil pattern Shouldn't have gaps in-between lines nor should it be fused to your bed lol.
Fun toy disk launcher I made as a fusion 360 project. It is fully 3d printable and uses a clamp system to launch a disk. Print settings -No supports -Brim for pin -15% infill -5 perimeters for the spring/squeezer! (helps for more power)…
Simple joint container with smooth threads It fits 1 ¼ papers at 100% but you could scale it to fit bigger cannons ;) Hold smell very well; you could add a rubber oring at the bottom of the threads if u wanted to seal it.
Good practice butterfly knife for learning fun tricks. Print at 100% infill for best weight. Scale to 50% for a good size (Fusion 360 messes with this for some reason) Printed with PLA -Split the blade down the center and glue them…
608 bearing I designed. Works pretty well and spins easily. Outter diameter = 22m Inner diameter = 8mm Width = 7mm I printed mine with a ender 3 pro with a .6 nozzle at .16 layer height and it works just fine.
This is a working comb balisong that I designed. It can be used for practice or just as a fun toy and cool comb to show friends. I recommend these settings as it worked best for me -Split the blade down the middle (Prusa slicer has this…
Simple Iphone Stand (Chargeable) I made it fit my Iphone X with a Otterbox and one of those card holders. Overall I made it 18mm so you can scale off off of that if you wanted. -No supports needed although I needed a brim
Cool Phone Dock that can be used while phone is charging Would recommend scaling the Dock to 125% - 150% depending on the size of your phone/case or if you have a card holder on the back like mine. Printed in PLA with supports (on build…
Quick Fusion 360 model I designed for the quick flexi contest. You can scale it down to 60% to fit on a ender 3 or similar build volume. Print at .2 layer height with no supports. Lower the model into the bed so that you get a good first…
Easy to print and a good test for your printer -3 1/2 hr print at .12 layer height - No infill -3 perimeters -I used a brim but that's up to you
Simple organizers I made for keeping track of bolts. It has a sliding top that feels like heaven lmao. Printed with PLA and no supports needed
These are all currently available results.
