Counting matching models…
This tool is handy for quickly setting the tension on late model KTM/Husqvarna/Gas Gas 125-501 dirt bikes that has a specified slack of 55-58mm, measured between the top of the swing arm and the bottom of the chain. Note: this has only…
This panel mount is minimal and strong, with accurate dimensions taken from genuine Anderson SB50 connectors, so this is verified to fit. Some other models online do not account for the ribs on the side of the connector, so the connector…
Change Log V3 Lower light bolt hole moved forward to allow for greater range of motion for lower light Reinforced the slot in the frame that interfaces with the lower headlight mount of the headlight mask. V2 Overhangs improved for more…
Works with standard GoPro mounts and should be attached with 3M VHB tape. Included is a provision for a safety wire to be tied into the removable snout of the helmet. Printed with 100% infill and 2 perimeters. ABS print file with custom…
I wanted to design a front license plate mount for my 2019 Volkswagen GTI (MK7.5). Required hardware: 3x 6" zip ties 2x M6 Brass Inserts (I used some from McMaster Carr ) 2x M6 Stainless Steel bolts (I used security Torx from McMaster…
I made this to mount the control unit of my Yaesu FTM-400XDR to the windshield of my ford E-series van above the mirror. It is meant to angle the head unit about 10° down and 10° towards the driver of LHD vans for an optimal viewing and…
I needed a holster of sorts for the wireless remote for my Warn Platinum winch. It's intended to be used in a center console cubby or glovebox. The slot on the back of the holster is designed to be facing “outwards” from the wall it's…
A storage tube made for Colby Emergency Valve Stems. It also doubles as an installation tool. Print instructions No supports necessary, printed with a 0.2 layer height.
Printed in Ninjaflex TPU with no supports at 100% infill
Required materials/tools: Small Phillips screwdriver for helmet disassembly Standard M6 nut ≥ 10mm M6 bolt Safety wire & 3M VHB tape OR epoxy Printing tips: ABS, PA, PA-CF/GF recommended Fuzzy skin optional, but it provides better…
This stand works with both the Pro and the Sport versions. Needed: 1x Diode Dynamics SSC2 LED Light 1x M5x50mm cap head bolt 1x Nyloc M5 nut
This tool is used to transfer the location of hole centers. It fits M12x1.75 holes; after printing, it's suggested to run a die over it to clean up the threads. The transfer screw can be inserted with an 8mm socket or hex bit. Printed in…
These are all currently available results.
