Counting matching models…
A friend of mine bought an ultrasonic record cleaner for his vinyl collection but it only came with 4 spacers. after searching all over the internet he couldn't find any additional spacers without buying the whole cleaner again. So a long…
a clone of a castle rock building block. I sliced with cura using special mode (mold) with the following settings. 1 : wall thickness = 10 mm 2 : angle = 45 deg 3: roof height = 0 mm Update: I use tpu filament to make it easier to remove…
I used freecad to create this model and cura to slice it with special-mode (Mold) enabled, the model was placed upside down on the build surface in the slicer and the settings were 1: wall thickness =10 mm, 2: angle = 45, 3: roof = 0.…
After looking high and low I made this simple connector to splice my shop vac hose back together after I had to cut out a small section that had a hole in it. This may work on other brands as well but I only have the one shop vac. I have…
My wife needed a method to organize her assortment of sewing machine bobbins, so i made this 20 bobbin holder tray. the lid for said tray is printing now so I will post in an update after it is done and cured.
I created this set of parts to work with my westune mag mixing plate from amazon. it will work with most mixing plates out there. it uses small magnets from ali express or amazon. i used the 3d printed 608 BB ball bearing while designing…
These are all currently available results.
