Counting matching models…
This bracket fits snugly around a Deutsch style 4-pin connector so it can be mounted to a flat surface. Prints well in PETG in the orientation provided by the stl file.
Anti-vibration mount for Cube autopilots using the Mini Carrier Board from CubePilot. I sourced the silicone ball mounts at this link on Amazon . The skeletonized bottom plate has easily accessible 3mm mounting holes. A solid bottom plate…
Landing gear mount for ZD550 quadcopter frame. Uses 3mm heat set nuts. Fits stock 16mm carbon tubes.
Magnetic Helping Hands similar to a commercial design from Europe that seems to always be out of stock. Additional parts required to make one "hand": 1 x 10mm x 5mm neodymium countersunk ring magnet 1 x 1.375" x 23/64" spring 1 x M4 x…
I wanted a way to monitor my garage doors in Home Assistant and created this simple hinged model to mount high on the door as a self-contained unit. Prints without supports (you may have to flip the sensor side 180 degrees to make it flat…
Press fit mount for helical GPS antennas. Intended to preclude crash damage to the bulkhead connectors. Printed in PETG.
UPDATE: tying the skids together like this resulted in some rather ugly vibrations/resonance. I made a new mounting solution to replace this one. Leaving these files here since the parts can be adapted for other uses. A set of clamps for…
The GepRC Naked GoPro has a much smaller mounting tab that is not compatible with the usual GoPro style mounts. This part fits in place of Shen's 3D printed GoPro mount to solve that problem. I used GepRC's included thumbscrew as a heat…
These short landing gear mount under each motor and provide enough clearance for a TeraRanger EVO LIDAR. They are quick and easy to print with no support required. I used PETG.
I accidentally ordered 2207 motors (TBS Grinder) for my Grinderino 5", so I printed these in PETG and used the same pattern as a drill pattern to elongate the existing motor mount holes. Probably not recommended, as it may weaken the arms…
UPDATE: The v2 model is a little chunkier with additional gusseting at the front to reduce flex. I also included the Fusion 360 archive, which is admittedly a bit messy. I was working quickly rather than methodically, which is likely…
This stalk mounts opposite the VTX antenna and is sized for the Matek M8Q-5883 GPS/Compass module. It is hollow so that wires can pass through. I used 3M mounting tape to affix the module on top. Printed without support in PETG. The v2…
I designed this specifically to fit the 16mm skid struts on the Readytosky ZD550 frame, but you should be able to modify it for other applications. The Fusion 360 file is fully parametric, though it may be a little error prone if you…
These are all currently available results.
