8 models
A quick soulution for the annoying task of strap rolling. Assembly order as shown on the photo. Printed in Extrudr NX2 PLA Recommended in PETG, ASA, PC or Nylon for better strength. 4-6 Perimeters 4-6 Top / Bottom Layers 15% Infill…
The quick solution for sweaty feets and smelling shoes. The dryer uses a standard 120mm pc fan to blow air into your shoes. Mount the fan with long screws or with zipties.
In general people use to much detergent for their washing machine. About 50ml are sufficient for everyday runs. Prints without supports.
175mm notched trowel for large format tiles, with hook 8*8mm spacing 3-4 Top / Bottom Layers 3-4 Perimeters
Quick connect chain adapter, that clamps together with 1 M6*10 counterscrew and nut. Print in flat position, 2x Link needed
The classic Tic Tac Toe get's an upgrade. It might look easy at first glance, but the third dimension changes everything. For one set you need: 1 base 13 crosses 13 balls
This is another spool holder no one asked for, but everybody needs… The holder can be printed in 2 orientations: printed flat, but support below the bearing cut out is necessary printed at 45° with modelled support to break off later,…
No more water in the end of your blender adapter. Holds up to 17mm in diameter and 175mm in length. Prints without supports.
These are all currently available results.
