Counting matching models…
Seen here printed in PETG for slight flexiblity (keep reading). This mount is slightly oversized in comparison to the shape of the Mac mini. I see this as a design feature as it allows the mac to be tightly held in place with friction via…
I discovered this part was broken on a family member's car causing misalignment of the bulb. A few prototypes later this is what I ended up with. Seen here printed in PETG which failed! The PETG melted from the heat in the end. I replaced…
Uses standard screws for the countersunk mounting holes. IIRC, they are supposed to be M4 screws - they measure out to 3.9mm. Supports a permament installation of the drive via a M2 socket screw at the back. The hole for the USB-C was…
Modeled after the Express 1M2 NVME TB4 enclosure by Other World Computing. It sold as an empty enclosure and also a complete storage drive from factory. I did not design this product, OWC did, hence the restrictive license and not being…
I put the radar point rearward to around 13 degrees from the car's center line. No azimuth errors so far. I used CR-V (TLA) radar in a Civic Hatchback (TGG) and so far haven't had any issues from that. The radar does report this on CAN in…
Printed in TPU. I think I used 2-3 walls and low infill to keep it flexible. Use supports! I got resonable air tightness by printing so the inward end of the model faces the plate, printing the tube horzontially. Once this part has been…
Simple board protector for this breakout board.
Modeled off of unit from a 2017-era Honda CR-V.
Add this to your model to create a mount for your radar retrofit!
These are all currently available results.
