Ford H11 headlight bulb holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement bulb holder for a H11 headlight/headlamp bulb holder in a 2015 Ford C-max. Modeled in Fusion (F3D Uploaded).
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 104
- Makes
- 0
- Views
- 330
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I discovered this part was broken on a family member's car causing misalignment of the bulb. A few prototypes later this is what I ended up with.
Seen here printed in PETG which failed! The PETG melted from the heat in the end.
I replaced it with PA612-CF, annealed after printing, which seems to be holding up to the heat.
Printed with supports as the bottom is not flat. The bulb positional stops were a bit long in my case and were trimmed after printing with a pair of wire snips. The fit otherwise was very good and installed without other issues.