Counting matching models…
3D model of the Porsche Boxster 986 and probably 911 996 frunk trim cover fastener. Porsche part # 999 590 036 40. Most of mine were broken or missing, so I remodeled them in CAD and printed my own rather than giving more money to the…
The windshield/wiper cowl on the Porsche Boxster (986) are notoriously prone to breaking. It's possible this may work for the 996 911 as well. When this happens the ends become loose and flap around and the cowl no longer makes a good…
Remix of the original screw on bracket to slide into the corner brackets on my Costco shelves in my garage.
My car was missing a part and you can't get them from Porsche anymore. I put my own spin on the part and created own bracket to ensure the cabin air filter doesn't pop out of its housing. Uses the factory holes and a couple of automotive…
I built a custom circuit using an ATTiny to drive an oil temperature gauge off the factory DME in my Porsche. I needed a vented enclosure for a 5x7CM prototype board and couldn't find any I liked with a snap on cover, so I made my own.…
I needed a bunch of cable clips to cleanly route the wires for my Garmin Catalyst power and camera wires. I whipped these up in CAD real quick and they are doing a nice job. Inner diameter of the clip is 4mm. Use 3M double sided…
This fitting clips into the hole on the bottom of my Pioneer mini split and holds the drain tube on the outdoor unit. The little plastic fitting it came with broke, so I made a new version to 3D print.
Needed a bracket for my Milton Autodrain for my air compressor. A lot of these types of things have the same type of tabs on the sides for a u-bracket. Rather than buying one I made my own in Fusion 360 and printed it in PETG. I used 25%…
Needed a good way to store and charge my phone in my 2025 Ram 2500 while driving. I wanted something for both long road trip (hard wire charging for Android Auto/Spotify) and something convenient for in town trips like a mag-safe charger.…
I created this mounting bracket to hold two combination volt/ammeters for my portable generator. Each gauge monitors one of the 120v legs of the 240v generator. Print this out in PETG, ASA, or something similar since it will get pretty…
These are all currently available results.
