Counting matching models…
This is a hardware-free, fully 3D-printable radiation shield designed to protect environmental sensors (like the FS400-SHT31) from sun and rain. By shielding the sensor, it allows for more accurate ambient temperature and humidity…
The AWQP team is working on a development and testing of a low-cost water quality sampling system. This system is intended to significantly reduce the cost of water quality research equipment. These devices will help reduce the cost…
This is a mount for the Grove Shield and can mount a battery, Lithium Ion Battery Pack - 3.7V 4400mAh The Grove Shield FeatherWing for Particle Mesh and all Feathers is an add-under for any Particle Mesh or Feather board, so that you can…
Solar Controller Mount for Low-Cost IoT Water Sampler This 3D-printable mount is designed to securely hold the 1 0A Solar Charge Controller (linked below) for the Low-Cost IoT Water Sampler (LCS) , developed by the Colorado State…
0.16 mm layer height. Print with TPU 100% infill. I printed with no support but will need to clean up and worked find. You can print with support
Model is 200x200mm. If you want it smaller just change the X and Y. Leave the Z alone Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA+ Elegoo Black PLA+ Elegoo Red PLA+ Elegoo Black PLA+…
This 3D-printable protective cover is designed to safeguard the eTape Liquid Level Sensor used in the AWPQ Low-Cost Sampler (LCS) , developed by the Colorado State University Agricultural Water Quality Program (AWQP) . The eTape sensor is…
These are all currently available results.
