Counting matching models…
I created a trash can that uses the FITS pocket to mount on the back of the center console. There are two versions. A shorter, thicker walled one that is more flush with the top of the FITS pocket and a taller one that has thinner walls…
I used two 10x3mm magnets to hold it closed. Use super glue to hold the magnets in the pockets.
I used superglue to attach the ends of the parts and connector pins. I also only used a small bit of support on the end piece which you can see in one of the printing photos.
I wanted fillers for the gaps between the front seats and the center console of my 2024 Ford Maverick so I don't lose stuff that could fall in the gaps. I made one for the passenger side and one for the driver's side. They are customized…
I wanted an easy way to dry out desiccant beads in my dehydrator. It has a funnel section to make it easier to pour the beads back into a container. It prints without supports.
I liked the original model except my plastic curtain and liner tended to hop off the hook when I slid the curtain. I recreated the model and increased the length of the two little hooks so the curtain and liner would stay on even when…
I wanted to have the switch for the Bento Box mounted to my enclosure so it was easy to access. I added a mounting plate to attach to the Prusa enclosure using some existing holes in the bottom plate. The bottom box can then be attached…
My glue gun was too tall and long to fit the previous model so I adjusted it to fit my Arrow TR550 glue gun. Prusa MK4 0.4 nozzle 0.3 layer 15% infill no support
I modified it to assemble with screws instead of glue. It uses two M3 screws and nuts and one M4 screw and nut to assemble the two parts together. I've included the STEP files in case anyone wants to modify it further.
I found the following USB extension cable on Amazon USA https://www.amazon.com/dp/B0CCMKQCPB?ref=ppx_yo2ov_dt_b_product_details&th=1 and changed the pocket so it could fit this USB extension cable. I also enlarged the M3 screw holes to…
Trying to get the adjustable rails set in the correct location was bothersome so I modified it to use screws and nuts on the outside of the rails and a press-in piece on the inside to lock the base pieces in the correct width for a…
I wanted to have a humidity/temperature gauge mounted in my dryboxes. I made one that uses a M3 screw and nut to mount the gauge on the inside of a drybox. The gauge can easily be inserted or replaced. It fits the typical gauge provided…
I wanted to make some tambourines for the grandkids. The models I found didn't suit what I wanted so I made one up myself. It prints in two parts that are glued together (there are posts and holes to align the parts for gluing) and use…
I wanted to mount a Wyze Cam OG to the outside of my enclosure so I can watch parts as they print. I originally had a camera mounted inside but the heat cooked it. I made a mount that attaches outside the enclosure using the existing…
The pin has grooves in each end for a clip to keep them from sliding out. It is flat on one side to make it easier to print. The clips are described below. "Wire Spring Hose Clamps, 32 Pcs for 4.5-4.8mm OD 0.16"(4mm) ID 304 Stainless…
These are all currently available results.
