Counting matching models…
I got a first-gen Nespresso machine eons back and immediately printed out some dispensers for the pods. In fact, these were some of my earlierst prints and the first functional prints allowed in the public spaces of the house. So when I…
A simple model to cover the controller on a Corne keyboard. I use the Corne HiPro Case by mburrows for my Corne keyboards. I don’t have an OLED though so I’ve been using the MCU cover from the Corne Choc Low Profile Case . Problem is that…
I needed room both for the large matrix controller that came with my LCD 1602 but also to fit a proper usb port into the side hole. The buttons on the Matrix controller are not accessible once the lid is screwed on. For me, M2.5 screws…
I couldn't find a 3d printable cover for the lily58's MCU. Which is … weird. But here's one now. IMPORTANT: The cover is not symmetrical. The hole placement on the board itself is strange and a symmetrical plate interferes with the…
Remix of a remix here. First, I ran the bottom through netfabb which resolved a lot of errors. Second, I remixed the top to significantly short the screw pole closest to the GPIO pins. This allows one to use a Pimoroni Fanshim inside the…
Due to some physical constraints, I sometimes solder at different heights. None of the fume extractor models fit the bill so I hacked these two together to put a Noctua 140mm fan plus charcoal filter on a microphone boom. Lets me adjust…
I wanted to make wall art with these pieces so I mixed in a hole for some pushpins I had on hand. I print four of these for every filament I have or samples I get. They go into a bin and eventually get put on the wall. The exact pattern…
This mount allows one to attach a Raspberry Pi 4 to a 3D Upfitters 3d printer enclosure . This is a base only and is designed to be used with any of the tops based off Malolo’s snap fit design Attach the unit to your favorite corner using…
These are all currently available results.
