Counting matching models…
Landing gear to keep the bottom of my 10" AliExpress Mark 4 drone off the ground. The landing gear includes holes for mounting the motor and cutouts for routing LED wires. This part was designed using privatives in Prusa Slicer. The .3mf…
Print approx. €0.71–€0.87 excl. taxPreliminary estimate for PETGSource material: PET
This is a tail to hold a GPS unit and compass away from interfering electronics on my ten inch drone. I printed the part using PETG. PETG is flexible but not as flexible as TPU. I'm afraid printing it with TPU would cause it to droop too…
Print approx. €0.75–€0.92 excl. taxPreliminary estimate for PETGSource material: PET
This is a way to test fit the C-40T gimbal without having the actual gimbal in hand. I used a 5M 25mm hex socket cap for the yaw axis. Two 5M 12mm hex socket cap bolts were used for the roll and pitch axes. A 10mm bolt on the pitch axis…
It's a good idea to use brims with this print. You need two of these parts for it to work correctly. Once the parts are in place, you may need to use some Channel Lock pliers to get the cover to snap into place. This model was designed…
This model requires a printer with ability to print using multiple filaments. The text is 2mm thick.
I was not satisfied with the range of my Pavo20 Pro 4S drone. I decided to upgrade the ELRS receiver to a RadioMaster XR4 dual band (GeminiX) diversity receiver. I attach the receiver PCB to the back rear of the O4 camera. The antenna…
These are all currently available results.
