Counting matching models…
Pry tool I used to remove my car's dashboard to install a new radio unit. The hotend temperature was a bit too high for the filament but it was good enough. Print instructions Category: Hand Tools Summary Pry tool I used to remove my…
Admit it. You don't mount your spools correctly. They're misaligned and they wobble as they spin and vary the tension as your print progresses. This stepped nut gives you effortless perfect angular alignment with the shaft at the expense…
Introducing the TurboSnail Part Cooler for the Pitstop Extruder. Expect this to perform on part with the Prusa shroud given a moderate bump in fan speed to compensate for the added restriction. The idea is to have a smaller, more directed…
I designed this to try to match the feel of my GT86. I printed mine with 80% infill for the extra weight.
A lamp assembled with interlocking joints. The front opening is 245x160mm and may be filled with washi paper, a careful inkjet print on vellum paper (as I used), or perhaps a 3D-printed lithophane. The maincolumn.stp file is provided for…
Extension of the Iris Gift Box for use as a larger container. Mine is printed at 150% scale and uses 9mm steel balls. The multicolor leaves require either an MMU or a handful of manual filament changes. Follow this guide for setup:…
Shock Mount for the Blue Yeti mic, or any mic that can mount similarly. A 5/8" mic adapter is suitable as a fastener. Two 12mm long M3 screws are required to mount to the IKEA TERTIAL stand. I used 1/16" OD paracord.
Repurpose an old eSun two-piece spool to hold desiccant. No additional hardware or glue necessary. This is particularly convenient if you are in the habit of using a dehydrator for filament spools directly. Dry and store in the same…
Robust mount with a shorter cantilever for higher strength and stiffness
This duct allows a 1080 Ti SC2 to draw fresh air into a Fractal Ridge. No case fans, no recirculation, no excess noise or heat. Install to case with M3 buttonhead screws and heatset inserts.
Extended dust caps to fit LED headlights on a 1991-2001 NSX. Fewer supports as a result of deleting one of the vents.
Reversing the direction of the original pedal bracket is required. Use the Anchor Bracket to replace the stock part holding the bracket to the rest of the rig. Remove the smaller diameter half of the tubular pedal bracket and slot it into…
Suitable substitute for part no. 90667-SL0-003
These are all currently available results.
