Counting matching models…
Fits 12mm hex found on most 1/10 scale cars. Sized for 48mm inner diameter tires that are 26mm wide. Pictured tires outer diameter is ~65mm. I print these with the outside face down on the bed with support only on the flat in the center…
Model details: The phone slot measures .55" wide 2x2 standard gridfinity bottom, with holes for magnets (this stand is stable without magnets of course) Printing details: I used .3mm layer height PLA 10% infill no supports needed with the…
Great for vining plants like Pothos! I'm using it to create a living wall in front of the window of my apartment and have been making seasonal decorative panels. The current setup is pretty sturdy and gets more solid as the plant is woven…
A simple case organizer that will hold 2 cameras, a spare battery door, up to 7 batteries if you have 2 on the charger, and will fit a 10k mAH Anker power bank in the mesh pocket for charging your batteries! Fits my Hero 11 very nicely…
Simple 1x2 Galaxy buds holder with 3 USB slots. Fits standard Gridfinity grids and has the magnet holes. Printing details: PLA is fine I used a .3mm layer height no supports needed, but the magnet holes get a little sloppy without them
I made a 5x5 gridfinity based rack to hold mix-branded open end, combination or box end wrench sets. The slots should be wide enough and spaced far enough for most any wrench set without padding on them. Would probably work for most…
Socket extension holders for gridfinity. This is for my collection of 1/2" drive ones. My toolbox is filled with mixed brands, so I oversized the pockets to accommodate that and future cross-branding. The 10" long one is too large for a…
Socket extension holders for gridfinity. This is for my collection of 3/8" drive ones. My toolbox is filled with mixed brands, so I oversized the pockets to accommodate that. The 10" long one is too large for a Prusa i3 bed, so I included…
A sockets organizer for those of us that have more than one brand of socket, or copies of the same size socket, in our toolbox! Works for any size socket that has a 1/4", 3/8", or 1/2" drive. Designed so that the base of the socket sits…
Basic plant pot with drainage and a dish, suspended by tree supports. I included the slicer file that I used to make the pictured planter on my MK3S+, you will need to be running Prusaslicer 2.6 to utilize the organic supports feature.…
I measured the attachment point on my mixer and offset the shaft a little bit for an easy fit while the hangar is attached to the cabinet. I also set the thickness of the hooks "backbone" thin enough for my cabinets to close over them.…
These are all currently available results.
