Counting matching models…
I wanted to remove the radius overhangs on the print but realised the original STEP files were exports of the STL so I've exported clean STEP files as well as made my minor tweaks. Thread was changed to GL20 thread to hopefully improve…
My head torch broke randomly when I was out on a hike and changing the batteries. I'd only had it for a month or two when it happened and didn't want to just throw it away because it cost a good £30. All that had broke was the latch that…
A simple remix of the MKII applicator for superlube tubes. Like the MKII simply insert and then twist until resistance and then apply the lubrication. Use the lid to cap off the applicator end.
I wanted some custom valve caps to protect my car tyre valves. I had used some metal ones before but they got welded to the valve so I wanted something plastic to prevent that but also hex headed so that if it did get stuck I could get a…
I bought a laser cutter and the ventilation pipe is 152mm PVC tube. To make my life easier when it's not in use I made these hose couplings so that the pipe can just detach when needed. I also made an adapter that can go against a flat…
A small little M19 plug with modelled threads to enable it to screw into the second rear port to blank it off. Tested on the FORMD T1 V1.1.
As you know, the Ribba frames have a terrible recessed wall hook, which makes mounting them a nightmare. I wanted some wall hooks that could be screwed to the wall securely so I didn't have a untightend screw in the wall. So I made some…
Just a slight alteration to the handle for something a little more to hold onto. Should fit Bagoons original heads without much issue. Nothing major other than the alternate handle style.
After having to transport my SL1S, I found that my resin tanks weren't very well protected. Whether that's the resin inside or the clear film print surface being exposed to scratches. I saw the CW1 tank cover and felt something similar…
Requires a laser cutter to cut the clear panel out (2mm thick) and needs M3x5 low profile screws to look good. The screws screw directly into the printed parts, just don't over tighten and damage the window or strip the thread. The…
I wanted to clean up my FORMD T1 V1.1 case and mount the SSD's next to each other. The original bracket doesn't allow this so I made this small little thing to enable that.
I bought a compost caddy that hangs from the mother bin but with the model of mother bin I bought it didn't fit. I printed a replacement handle with a lip of it so that the compost caddy can hang on the front. The mother bin I have is the…
(WIP) – This is a work in progress, modify your laser at your own risk, I take no responsibility for damaged lasers or personal injury. There are known flaws with the system at current which I’ve listed below but it is not an exhaustive…
These are all currently available results.
