Counting matching models…
Custom-designed flow rate test print. Instead of doing a monotonic top layer infill, you could do a concentric one. If it fills it from outside to inside, then any surplus gets squished towards the inside, and it's really obvious if…
I've printed this in PLA, but TPU might be nicer. In PLA it's quite sensitive to clearance, so you can adjust that as a parameter in the Fusion360 file. The current clearance works for me on my Bambulab X1C printer, with a layer height of…
Should print-in-place fine with your favorite settings, as long as your printer is happy with 0.2mm clearances. I've printed it in PLA and in PETG. Will probably need some gentle un-sticking after printing; try to put a knife tip between…
The problem I've had with Polyterra spools is that the cardboard circles are not concentric, so they wobble in the AMS. This still happens if you add rims only. With some you can tear off the cardboard carefully and transfer them to a…
Parametric bin and grid, with x, y, and u. The stacking lip has notches to prevent sliding of stacked boxes No magnets. Recommended way of using it: For the grid, just use as-is. Open the file, edit x and y, and export to your favorite…
Remade the model to allow more bending between two rows. Still prints without supports. If you turn on “make overhangs printable”, then you can even print it with the hexagons upwards, if you prefer that. After printing, let it cool down…
Had to make a diagonal holder so the drawer could close! Looks pretty neat this way anyway. Should print in place, no supports.
Besides these rollers, you'll need to remove the tabs from the Hydra AMS main body to allow bigger spools. The rear rollers are fairly straightforward. Print, assemble, transfer over the bearings from the stock AMS rollers, and they…
The stock protective case that you get along with an Unihertz Jelly 2 doesn't rise up above the screen, so it doesn't protect the screen from scratches when lying face-down. This case has risen sections in the corners so you get the…
I used 8x12cm ziplock bags from aliexpress and a generic stickersheet that I printed onto for the labels. The ziplock bags are convenient because you have a place to put your resistors if you want to keep them after ripping them out of…
The model has some tight tolerances, so you need a well tuned printer, or you can increase the x-y compensation a bit or scale up the model a bit. Personally I print it with lower layer thickness (eg 0.1mm) to reduce the scratchiness of…
These are all currently available results.
