Counting matching models…
For fastening the honeycomb storage wall grid to the wall. This was a simple change from @roryshko's excellent ‘empty’ countersink model to use an 82 degree fastener instead of 90 degree. Also included are through hole versions, all with…
Ordered the switch from @EricU_224846 ‘s model then realized it wasn’t V2 compatible. Just placed the 12.5x19mm pocket in about the same spot and ran a cable passage.
Adjusted the outside dimensions and added 3x3 bases on the bottom. There is also an untested model that makes this stackable, though harder to get at the parts. If you're using clickfinity, I recommend not using PLA as it will creep over…
My goal is to replace all the mishmash of fastener bins with filament efficient and strong bins. This prints in just over an hour and with 34g of filament. It has 6 bins in a 1x4 footprint and fits standard labels. I love the divided vase…
So you can hang your film sticking fixture on your honeycomb storage wall. On the wiki , this is called the Bambu Lab Sticker Applicator.
This remix is a simple change to switch out the peg with the clip feature.
Increased the opening to fit my USB-C cable Replaced the lower fillet with a chamfer to avoid steep overhang Made wire escape run all the way to the root for hopefully improved cable routing
Bought the filters from @jingerale's model then realized it wasn't compatible with V2. Still printing the Bento so appreciate feedback on adjustments needed. Only change to the V2 model was to widen the opening to match the ILIFE 42.5 x…
The only change was to remove the magnet holes on the bottom of the part since I don't use them.
This holder uses the magnet locations from Apple's case accessory document . Hidden in the back is a cubby for an 18650 pack to keep the iPad charged up on long sessions. This one is a New Trent IMP120D, which appears to be discontinued.…
This model pulls the compound curvature surface from the speaker into the stand for a clean look. It has 4 bolt holes, though I'm only using the back two. The front two require a shorter SHCS and some creativity on torquing. I printed the…
There are 4 feet for each corner of the machine. The back left has a cutout for the energy chain to leave it untouched. The feet have a feature to capture the existing aluminum bent sheet metal and hold them nicely. Recommend many top…
Pretty simple holder for some pointy boys, just waiting to stab you. Locate these in a spot on your grid where that's less likely. Designed for this cheap set of bits: https://www.amazon.com/dp/B07MML1SRQ COMOWARE Countersink Drill Bits…
The fan case has an inside radius of 4.4mm. If your fan body has an outside radius much tighter than that (2mm in my case) the fan doesn't seat on the edge. This causes the hole pattern to be misaligned. This is a simple remix to make the…
I have a Lutron Motion Sensor ( MS-OPS5M-WH ) controlling a bathroom fan and light. Despite having user adjustable settings for sensitivity, it triggers whenever I walk by the bathroom. This wastes electricity and annoys me with the relay…
These are 1x2x6 (42mm) bins which hold the bolts with the clamps, then another to hold the wingnut with thumbscrews.
Matt Parker of Stand-up Maths covered Donald Grace's 1962 discovery in a recent video. It's the global maximum largest 8 vertex shape to fit inside a unit radius sphere, and potentially the first shape found via computer and not humans.…
Wanted to incline the HD6 up, but the wobbly sheet metal parts were no good. This is a solid base which can be filled with sand and inclines at 9 deg. Option to use a plate of steel to close it off. A Kanto stand top plate was reused in…
These are all currently available results.
