P
PrintablesJoseph Helmstetter Jr
Filament Dry Box with Rollers (all printed parts plated)
Used OrcaSlicer to plate all printed parts to build one drybox. Takes about 6 hours t print on a Bambulab X1C
- Downloads
- 836
- Likes
- 209
- Rating
- 5
All models
Counting matching models…
P
PrintablesJoseph Helmstetter Jr
3mm Shim/Stand Off
Needed a stand off and I didn't have any. Designed this out of necessity. The ID is 3.2mm, OD is 5.2mm and I uploaded heights from 1mm to 10mm. Its probably best to print these at 100% infill.
- Downloads
- 104
- Likes
- 17
- Rating
- 0
P
PrintablesJoseph Helmstetter Jr
Sand/snow Ski for ice chests
A ski to make pulling ice chests with thin wheels through the sand or snow. Uses 550 paracord and a paracord lock (see below) to secure the ski to the wheel axle. Supports up to 215mm diameter x 80mm wide wheels (about 8.5" x 3.125").…
- Downloads
- 22
- Likes
- 5
- Rating
- 0
P
PrintablesJoseph Helmstetter Jr
Xtool F2 Ultra Screen Handle Mount
I used 3x12mm socket head cap screws and used the original handle on the inside to screw the mount into.
- Downloads
- 15
- Likes
- 2
- Rating
- 0
P
PrintablesJoseph Helmstetter Jr
Duet PanelDue_5i Display case
Created this case to hold the PanelDue. It is a tight fit and I found that if you install the display at an angle with the SD card side going in first. Then carefully press the display into place. I also included parts for mounting to…
- Downloads
- 11
- Likes
- 1
- Rating
- 0
P
PrintablesJoseph Helmstetter Jr
Duet3d WiFi case - 2020 Mount
External access to the reset button and SD card slot. It has a place for a 40x40x10 cooling fan and several places to zip tie wiring down to keep it neat.
- Downloads
- 7
- Likes
- 1
- Rating
- 0
These are all currently available results.