Counting matching models…
by wichiman I made some changes. I found the clamp was too narrow so it was hard to clip on. I cut the opening a little bit. Also I made the feet thinner, from 5 to 3 mm, but without the clamp. It is still 5mm thick. I recommend PETG for…
I saw there was a model for the FLSUN V400. This is for the “legendary” FLSUN Super Racer.
Original description below I print this cause I needed it. My Xiaomi Poco F3 doesn't fit in the remote controller. This fits perfectly, I printed without support on my FLSUN Super Racer. Print it on the side…
by OoeyDuck is licensed under the Creative Commons - Attribution - Share Alike license. Summary Made this because there's only one other tool holder I know of and it couldn't hold all the tools I wanted. Updated: Added more room for probe…
Create this model for a friend. It fits its bottles.
I needed a switch for the lights I installed to illuminate the bed of my Super Racer so I integrated it into a top pillar plate.
Honestly, the only feature of this printer that I've never liked is having the filament spool on the top and having to thread the filament through the lid. So, I searched for a solution on various 3D model sites without ever finding…
Fan case, adxl345 and bmg lite (or cable holder) 220515: Small update on the Axdl support. The holes were off by 0.5mm Layer height of 0.2mm No supports needed To fix the housing two M3 nuts and 2 screws M3x12 are needed (If needed I can…
These are all currently available results.
