Counting matching models…
Since the original was copy right struck on a different site, I redesigned this doll stand for generic fashion dolls of about 25 to 30 cm height. These dolls may or may not attend schools of secondary education, potentially with a…
This spice rack is meant to be mounted to a wall or cabinet door. It's designed for bottles with a square base of 45 by 45 mm, which I bought from Amazon . The x1 Version is a holder for a single bottle the x3 version is a rack for three…
Cap with integrated crank-clip for the Comandante C40 (Mk4) The cap uses friction on the inside of the grinder (i.e. the metal not the wood). There is sufficient clearance so the wood veneer should not be touched by the cap. Make sure…
The model is meant to be printed in TPU, but any material with some flex might work. I recommend using 6 shells, leaving the core at low density so the clip is a little more flexible as shown in the screenshot.
This Armrest is designed for the Golden Tone AC1, if it were to fit on any other banjo it would be purely by coincidence. The model can be printed without support and works in PLA. The clip is pretty tight though, so a more flexible…
The lines are multiples of .4 mm and will look best with a nozzle of that size. The symbol and outline are separate bodies that can be coloured in if you're using something like the AMS. Alternatively you can easily change colour by…
These stands are made for Moyou, Überchic and Maniology stamping plates and will fit 13 of the size 145 x 95 x 0,8 mm plates and 10 of the size 125 x 65 x 1,6 mm plates. No supports are needed and the material doesn't really matter. Do…
Material choice is pretty much irrelevant. Needs double sided adhesive to be attached. I recommend playing around with different bottom infill patterns for aesthetic purposes.
The tolerances for this model are fairly tight, so make sure to calibrate your filament first. Since the thread pitch is very fine, I suggest you at layer height of .12mm or smaller for the threads to work properly. The model of the hood…
No supports needed. Around 30% infill and 4 walls should be sufficient. I recommend using at least PETG though PLA-Plus may work too. Should the focus ring be difficult to turn after assembly, screw in the Tairs focus limiter screw a bit…
Pointlessly overengineered diffuser for the Intl-outdoor Emisar D18. No supports needed. The inner layer is integrated in the 3mf as a second component, so you can remove it in the slicer, if you prefer. Do consider that the flashlight…
No supports needed when you print the model with the opening facing up. Do keep in mind that the MF01 can run pretty hot when running it with a diffuser.
These are all currently available results.
