Counting matching models…
This is a shroud for the 15/30/45 amp series of Anderson Powerpole connectors. There are two files: One with a 0.24" cable opening, and one with a 0.16" cable opening. Both are included so you can drill out the size cable you need. I'd…
This cable housing was used to hide the solder connections between a 4 conductor mic cable, and a 2 conductor mic cable (Mogami 2534 to 2549). One half is slightly taller, so you can situate your cables in that one before putting the lid…
This is a battery holder for a 4s pack of 26650 size cells. I made this primarily for powering my Sound Devices MixPre-D, but you could use it for other stuff too. It consists of 3 parts.... a case, an inner support that holds the…
These holders are for supporting the Rode M5 mics at a 110 degree angle to each other within the Rode Blimp 2 windscreen. A standard XLR connector will not fit on the back of these mics in this configuration, you have to get creative and…
This is a mount and retaining ring for an 8 inch diameter telescope mirror. I recommend printing this out of rigid material, like PETG+CF or PLA+CF, and make sure you measure and compensate for any material shrinkage, as the tolerances on…
This model is a housing for a stereo binaural microphone. I made this in the likeness of Crown's SASS mic for my nature recording hobby. It's posted here in hopes that you can make some use of it for your own recording adventures. The 4…
This drum has ribs inside to help toss the media each revolution. The drum is about 8.2 in wide at its fattest point. Connect to it using a 1" diameter rod, or a plate with 6 holes in it, or both! I would recommend printing it from…
The goal of this design is to create a small, lightweight ORTF holder for the small "clippy" mics found on MicBooster. The mics are held at 17cm spacing at an angle of 110 degrees. There are 3 files that need to be printed. Support for…
Holder for Sennheiser 8040 microphones (or ones of similar shapes) Uses 2-56 threaded inserts to allow an elastic shock absorber to support the microphones. Threaded inserts are part number 93365A110 from McMaster Carr. Category: Audio
This is an adapter to allow the Rode blimp windscreen to be directly mounted to a tripod without the handle assembly. For the 1/4-20 tripod connection, this uses a 1/4-20 threaded insert: part number 93365A160 from McMaster Carr I printed…
This is just a little jig to help splicing microphone cable (or other cable). The diameter is 0.3 inch, and length is 1 inch. There are 3 channels along the length to allow the spliced wires to maintain their separation. To use this, cut…
These are all currently available results.
