Counting matching models…
I love my DJI Mini 3 Pro and its incredible DJI Rc(with the screen). I often use it in hikes and I want to be able to throw the drone and RC in the backpack, having it taking the less possible space. I've made a protector, that also allow…
I always wanted to make a candy dispenser since I baught my 3d printer, here it is. It has a anti-return (replaceable) mechanism, doesn't need any support and just required some screw. I've tested multiple versions to not crash MMS, but I…
I've built an enclosure with an Ikea Lack. Recently I've baught a Raspberry Camera High Quality(the one with interchangeable lens. I created a mount, which can pivot in 2 directions. I've printed it without support. It requires: 1x m3…
I wanted to have paper towel holder that slides in the slot on the side of the bed. Easy to insert, no tools required. You will need two side pieces( printed mine without top/bottom layer and kept just the hex infill) and two pieces for…
I love how nice the battery cover of @mfischer79 fits, but as I've the “FlyMore” pack, I usually have one battery in the drone, and 2 in the backpack. So I just edited the model to have 2 battery in one block. It fits perfectly, have a…
In order to heat above, I designed this adapter. You need to buy one flexible aluminium pipe to connect the two element(something around 9-10cm diameter, I'm not exactly sure anymore. Then you can connect one side to the vent: And the…
In my VW California, the traditional “4-pin” tools are too bulky to unscrew the gaz regulator. This is used for some gaz regulator like this: This is a remix from Gaz tool nut by Dragonjojo - Thingiverse I've reinforced it a bit to…
The VW T6.1 Ocean has a small sliding storage on the side of the wardrobe, but it was too small to hold spices. So I made one. It clips on the shelve, still allow access to it and allow 4 standards spices. Works perfectly for me, no…
I found the catapult of @Lilimill2000 incredible, but without gluing it, it was dismantling quite quickly and the “stop bar” was breaking quite easily. What I modified: The stop bar is now larger and can be clipped to the model. It gives…
I was having some small ambiance light in the Cali. At first I just used some ducktape, which was working but it was a pain to close the upper cabinet as the lamp were getting stuck into it. So I made some extensions that allows have some…
Remix to only have 2 sheets instead of 4 in the original Print instructions Place the model on the flat bottom side. Rotate it by 45°. This way it should fit within your build surface.
Everybody living in a van has already had his glasses moving around while driving. This small thing is made to held the glasses perfectly. I just used some double-side tape to stick them to the side of my cupboard. Free to print them for…
I was looking for a nice and easy way to attach my Motorla T82 radio to my paraglider. I tought that the peak design attach was a nice, non-permanent way. You need the original back clip of the t-82, which goes through this adapter. I…
I baught plenty of Ikea DRÖNA, and I wanted to have some label to easily know what is inside of which one. The label holder is a bit tall, but I wanted it to be the same height than the ribbon of the DRÖNA. The pocket for the label is…
These are all currently available results.
