Counting matching models…
Corner things for my Ikea coffee table which has generously large radii and also holds the glass plate in place. We've fastened it with hot glue. I've printed it with a 0,25mm nozzle at 0,05mm layer height for a very smooth surface.…
An adapter ring made to accomondate the 32mm FJVR mounts using the Ally adapter for 34mm RAV. This ring is used along with one part of the original adapters which are included in the thermostat packaging and are installed by hand so no…
I removed the part between the two wall contacts and I added a bit material near the top one. Also, I've made an adapter "jacket" for 3,5mm countersunk screws to be used because the angle is too steep in the original design and hole size…
A fan duct that spits out the air both from the sides and from the front. The "arms" that ducts air to the sides are made to immitate a flow-optimized design with large curves and an internal rib to guide the air but no CFD analysis has…
Mouthpiece for https://www.thingiverse.com/thing:4748907 but which fits a NILFISK vacuum cleaner by having a constant inner diameter of 31,9mm for the first 20mm. It is a slight press fit onto the original part. Category: Hand Tools
Tool to clean into and behind my radiator. The mouthpiece has an inner diameter of Ø35mm which narrows to Ø33,5mm 20mm in. This fits many types of vacuum cleaner hoses. Print as many extension pieces as needed to get the wanted length.…
A funnel/intake tract for the print fan. By gradually decreasing the cross-sectional area leading down to the intake of the fan, the performance of the performance of the fan should increase. This is however most probably grossly…
My vacuum cleaner was not making a proper seal against the bag so the dust would go past the bag and clog the filter. This part is inserted into the inlet as a slight press-fit and sticks into the vacuum cleaner bag so that the dust must…
An intake funnel/tract for the hotend cooling fan of the Prusa i3 mk2s. By gradually decreasing the cross-sectional area towards the fan and ducting the air into the fan blades, the performance of the fan increases. The funnel is cut on…
I printed without top and bottom layers to ensure that there's no internal volumes that can expand when heated. Also, external perimeter extrusion width 0,50mm and otherwise perimeter extrusion width 0,55mm. 0,4mm nozzle. Detect thin…
These are all currently available results.
