Counting matching models…
1. Set Infill to 0% Go to Print Settings → Infill → Set to 0% This removes the internal fill, but the walls remain thick. 2. Adjust Wall Thickness In the Shell / Perimeters section, modify the wall thickness: Wall Loops / Perimeters – set…
1. Set Infill to 0% Go to Print Settings → Infill → Set to 0% This removes the internal fill, but the walls remain thick. 2. Adjust Wall Thickness In the Shell / Perimeters section, modify the wall thickness: Wall Loops / Perimeters – set…
Additions parts 2 x 608 bearing Dia 22mm. Thickness 7mm. Hole 8mm 1 x Hygrometer 1 x Connector M10 or M6 16 x Magnet 6x2 1 x Nut M8 1 x Bolt 8x45-50 maybe even 60mm fits not sure 2 x Screws 3x16mm 2-4 x Screws for wall mounting. Mounting…
If you print a Rocker hook then the second hook must be mirrored. Resolution: 0.2 mm Wall loops: 5° hook 5-loops / 30° hook 10-loops Infill: 5° hook 20% / 30° hook ~40% but more is better Material: PLA , PETG Supports: No Brim No Screw…
Nozzle 0.4 Layer hight 0.2 No Support Details are 2x100x100mm Use a textured plate. Print upside down to get a good surface quality. The track lines are 0.2mm deep. Use the support function to achieve a flat surface on the track. Or use a…
Hole(6.3mm). The distance between the center points of the openings is 38mm
Resolution: 0.2 mm Wall loops: 3 Infill: 15% Material: PLA Supports: No Brim Bottom connector may need The details are not in the correct printing direction, so you have to turn some of the parts into the correct printing position yourself.
I've tested some sessions. It works, it didn't break, but I injured my foot when I landed hard from a jump. XL too high. But if you don't do jumps or can land smoothly, then it's ok. ⚙ Recommended Print Settings Layer height: 0.16 mm…
These are all currently available results.
