17 models
Print without support. In Prusa slicer it is better to use Classic perimeter generator (instead of Arachne) and disable “Detect thin walls” setting. For fast printing increase number of perimeters to 4 (for 0.4 nozzle) and disable “fill…
Better to print from temperature resistant filament (ABS, PETg) and without supports
Print without supports XT60 connector must be glued for convenient usage May be it fits also 7, 9 and 10 inch variants. Bonus: wires protection. Must be printed in vertical orientation. Alternative version for slightly smaller dimensions…
Can not be used by katcaps
Print without support Put wires through the plug from side (like on first photo) Solder wires to USB pincs on pcb Put a drop of glue inside case Push connector inside with little force (table surface can be used for alignment)
Simple guide to twist 2 wires with drill. Can handle all diameters between 1.0mm and 3.2mm (AWG 24 to AWG 8) Must be printed with “external perimeters first” and first layer slow speed (10-20mm)
Can be printed without supports. Wires protection must be printed in vertical orientation
Most of parts are printed with soft TPU Top plate must be printer with strong and durable filament (ABS CF, ABS GF, PETG CF etc.) Not for ruzzke
Use strong plastic and 100% infill. Preferably print with Fuzzy Skin for grippy outside texture and:
Can be used with any 14mm RC cameras. Print with soft TPU. I recommend to print two or three at once (even if you need only one piece), because of possible insufficient cooling and fast print time Tested on: Caddx Ratel 2 Caddx Ratel Pro…
To make Meteor75 Walksnail version you need (not affiliate links): Bare drone (BetaFVP Meteor 74 pro O4) without DJI VTX (https://www.aliexpress.com/item/1005008676522575.html) Walksnail Avatar 1S V3 VTX…
wings lock must be printed in vertical orientation with 3 supports:
Cut excess wires from back side of pcb to save vertical space Cut stainless pipes, leaving approximately 5mm for both tubes Print both sides with supports Sand plane slightly for better connection Assemble like on photo Apply small amount…
Print with any plastic without supports (bridges enabled) More info in this video: https://www.youtube.com/watch?v=OZc5GKi1V Official site: https://docs.lilka.dev There are variants for 11.4mm, 14mm an 16mm height (for various battery…
I designed this funnel for quick pack large quantities of small 3d-printed items into zip lock pouch. Can be used directly from glass heatbed after cooling Must be printer with 3 perimeters, large side down and without supports Video of…
print with any TPU-like material
Front top canopy for Zohd Drift rc air plane. Print at angle with brim, 2 perimeters and zero infill: I made square hole for magnet. Glue it with CA or epoxy
These are all currently available results.
