Counting matching models…
Use this feeder feeding baby chickens. The design limits chicks ability to scratch out the feed, thus reducing waste. I didn't create a domed lid yet to keep them off the top, but then again in practice, they didn't climb on top anyways.
Print approx. €10.90–€13.32 excl. taxPreliminary estimate for one variant
Use this big funnel to pour sugar into large jar for making sugar syrup for bees. Nice wide neck to fit in plastic jug to maximize sugar flow into jug.
Print approx. €13.22–€16.16 excl. taxPreliminary estimate for one variant
There are other Post=it note stencils out there for “To Do” lists. However, these other stencils have nine (9) lines, which are too small for my writing. So, I created this stencil/template with only seven (7) lines. This leading is…
Idea came from convention giveaways. Theirs was too small. Created this one for larger fingers.
Made with PTEG at 15% infill. Ultrasonic jewelry cleaner bath water is slimy. This will keep your rings in one place and easy to retrieve when cleaning cycle is finished. No wet, slimy fingers and rings don't bounce around on the bottom…
After a branch fell on my chicken roof and punched a hole through the corrugated roof. Rather than buy a new panel and waste most of the material, I modeled a small patch to repair the hole. Print with PLA and supports from the bed only.…
A nice way to hold your thick cased iPhone 15 Pro (Spigen case) in a vehicle cup holder. Printed with PLA with organic supports from build plate only.
This print is for holding addressable LED's used in this project: https://slingtsi.rueker.com/making-a-led-powered-metar-map-for-your-wall/ Using clear filament, for penetrating the foam board and using this model to hold the LED, the…
Install inline in downspout to harvest rain water for use in gardening or filling water bucket for animals to drink. Two models, depending on hose size. ½" tubing or 5/8" garden hose slip onto tap. Made with PETG. 15% infill, supports…
After printing paint with clear epoxy to seal if using for chopstick holder.
I use this to attach my Insta360 remote to the windshield roll bar in my Van's RV7a. Print using PETG, no supports needed.
15% infill. After printing, attache to wall or surface using double back mounting tape.
Original file source cannot be located. I used this vase to display the Calla Lilly's that Mark created. Printed with SUNSENKJ Tri Colors Silk PLA (Gold+Blue+Fuchsia).
I was looking for a simple easy to make live mouse trap to catch the little home invaders and relocate them to somewhere else in the food chain. I looked on several websites and found this one, which proved to meet my criteria. Print…
These are all currently available results.
