Counting matching models…
This adapts from 35mm ID Fox springs found on many shocks (DNM Burner, DVO, Cane Creek) to 38mm ID Rockshox springs. Make it from something with good compressive strength and 99 perimeters. As shown briefly in this video.
Allows you to adjust the floodgate opening amount on motion control forks with non-adjustable floodgates. Print instructions PLA works fine. This prints as a single layer so just scale it in Z to adjust the amount of shimming you add,…
Add a standard 0-1 dial indicator to the strightness tester to complete. See this video for usage instructions. https://youtu.be/WTVM7WTz8fc
Has the rubber delaminated on your shark vacuum front wheel? Does you little robot lurch and bump around and try to take his little docking station away with him? Well that means you need a new front wheel, that you can't buy. Purchased…
A bleed cup for DVO forks that have 22mm hex on top with a baffle to prevent fork oil geyser. Print it with TPU. If yours is a little loose on the fork you can use a zip tie around it, but if your printer prints to size it will be a press…
Remixed Constructors design to add some undercuts to make sure the small rads caused by the print wouldn't interfere with the lathe interfaces and added some other rads and chamfers so it would print cleaner. Print with whatever setting…
A replacement hopper for the Smart Grinder Pro, I was unhappy with how small the opening and volume of the hopper was and I am not a fan of weights to prevent popcorning. It is sized to fit this bellows at 100% size…
Remixed Constructors design to add some undercuts to make sure the small rads caused by the print wouldn't interfere with the lathe interfaces and added some other rads and chamfers so it would print cleaner. Uses heat set inserts. 1 M3…
Special wrench for removal or install of the basevalve on the DNM Burner RCP-2S Shock. Print it with 99 perimeters. You'll also need to supply 4 2.5mm dowel pins that are 20mm long. I used mcmaster pn 91595A078. As seen in this video.
This tool will put a 7° bevel on your ski sidewalls with the bottom flush with your metal edge. You will need some parts for this one. BOM 5X 625 Bearings and seal is fine 1x M3x10mm SHCS 5x M5 x 15mm SHCS 1x CC09T304N turning insert,…
Makes re-filling shake and pour bottle much easier, probably fits more than just Kodiak brand, just compare the thread, this is M36x4.0. Print it thread side up, 0.2mm layer height for at least the threaded section. ABS + vapor smooth…
Crank for raising and lowering the table on many free standing drill presses. Designed to reuse the knob with M10 stud and nut with 14mm wrench flats. The drill press mounting side is a 30mm shaft that is 12.7mm across the D flat. The M6…
These are all currently available results.
