Counting matching models…
Update 1.3: Tightened tolerances on stud shaft and hex head close to v1.1-1.0. Threads almost like 1.2. RackStuds - a strong™ threaded fastener. This two-part design aims to make 3D printed mini-racks a lot more fun and accessible by…
I printed the model on a Bambu P1P using PLA. 3 walls ensured plenty of strength in my case. No support needed when printed laying on its side.
A simple frame to cover cracked corners or change the appearance of your Nest Hub gen 2. It features significantly rounded display edges, which gives it somewhat of a retro appearance. I achieved a perfect snap fit when printed on my…
Shelf-type wall mount for a Huawei Mesh 7 unit. The countersunk screw holes have a single sacrificial layer that pops once a screw is pressed in. Print settings: Printed on a Bambu P1P using PLA. 3 walls for strength and to avoid…
If you just want to attach it directly to a wall, use these attachment points . Use as many as you want, minimum 2. Space them out at any interval of 25mm. This battery dispenser features an S-shaped magazine to reduce jamming risk.…
Print two - one for top and one for bottom. If you just want to attach it directly to a wall, use these attachment points . The hole spacing is at 25mm intervals. You will minimally need two of those mounted 100mm apart vertically. For…
Two or four of the same part can be used to bolt into each corner of a 19" 1U device. The four snaps and 1U device will in total consume 20x2 CU (500mm x 50mm). Smiley face up, sour face down. Of the two holes, the one closest to the…
These are all currently available results.
