P
Printablescmenard
30x30 to 20x20 Flight Controller adapter
This is a 30.5mm to 20mm FC adapter. The 20mm mounting uses 2mm screws and can be tapped as is. Fits my Xrotor nano stack perfectly! Category: R/C Vehicles
- Downloads
- 710
- Likes
- 14
- Rating
- 5
All models
Counting matching models…
P
Printablescmenard
SKR V1.3 Case for MPCNC
** Added Bottom that will hold a 15mm thick fan. ** Added lid with V1 Engineering logo I increased the size of the hole for the wire entry and shrunk all bolt holes to 2.75mm for direct fit of 3mm hardware. Also created a basic flat top…
- Downloads
- 41
- Likes
- 4
- Rating
- 0
P
Printablescmenard
MakerGear M2 Extruder Mount for BLTouch E3Dv6/Revo Hotend
Decided it was time to update my old workhorse the MakerGear M2. This mount allows the addition of a BLTouch sensor without loosing too much useable bed space. I'm running this with Marlin 2.1.2 and here's a link to my config files.…
- Downloads
- 34
- Likes
- 3
- Rating
- 0
P
Printablescmenard
BigTreeTech TFT35 V2 Magnetic case
My TFT screen required more clearance for the mounting depth. Moved the surface down 1mm. Also recessed the 3mm nuts 3mm deeper to use 15mm length hardware. Print Settings Printer Brand: MakerGear Printer: MakerGear M2 Rafts: No Supports:…
- Downloads
- 26
- Likes
- 2
- Rating
- 0
P
Printablescmenard
MPCNC Stepper Bracket
This was remixed to allow for use of 1.25" aluminum angle. Added a notch on the bottom to clear the wires on the stepper motor. Also the holes have been moved for the 15mmX20mm drag chain found here:…
- Downloads
- 19
- Likes
- 8
- Rating
- 0
P
Printablescmenard
MakerGear M2 E3D v6 Filament drive
This is a remix of the rsilvers E3D v5 filament drive. Provisions have been made for the PTFE tube and Bowden connector on the 1.75mm universal hotend. Category: 3D Printer Parts
- Downloads
- 18
- Likes
- 2
- Rating
- 0
P
Printablescmenard
24x24 FC mount for Matek F411 Wing
This mount is intended to glue into your aircraft and allow mounting of the Matek F411 Wing flight controller. Category: Models
- Downloads
- 14
- Likes
- 1
- Rating
- 0
P
Printablescmenard
QAV210/180 Rear LED mount
This is a mount made to hold the following LEDs: http://www.readytoflyquads.com/led-decoration-board-set-7-30mm Will fit both the QAV210 and the QAV180 from Lumenier. Category: R/C Vehicles
- Downloads
- 10
- Likes
- 0
- Rating
- 0
These are all currently available results.