Counting matching models…
This is an external housing that attaches to the front of the Official Prusa MINI enclosure. This design only works with the door hinge mounted on the left side. Required hardware: -3x M3x8 screws -1x M3 nut -Reuse the 4x M3 screws from…
I created this pole mount for attaching my Desk Stranding lamp to my existing monitor mount. It is designed to fit a 35mm pole. Additional hardware required: 2x M4x12 screws 2x M4 nuts (The same M4x20 screw and nut from the Desk Stranding…
Make your MINI look like a CORE One! This ventilations grille replaces the clear acrylic panel at the top of the enclosure and can be printed entirely on your MINI. Required Parts 4x M3 screws (4mm is ideal, but longer is fine) 4x M3 nuts…
I used a couple of spare M3x10rT screws and M3 square nuts that came with my Core One kit. Print with 3 perimeters and 0.20mm layer height.
This mount uses magnets to hold the Voice unit in place. Press the magnets into the 4 posts on the printed model. I recommend using a right-angle USB-C cable to connect your power source. Requires: 4x 4x2mm magnets 4x *ferrous/magnetic*…
Card & token organizers for the board game 'Horizons of Spirit Island'.
Required Hardware 4x M4x8mm socket head bolts (front panel) 4x M4 nuts (front panel) 6x M3x8mm socket head bolts (rear panel) 6x M3 nuts (rear panel) 4x M3x12mm socket head bolts (for mounting the MiSTER Pi stack) Optional Parts Front USB…
Can be mounted to the wall with a single ~4mm screw or command strips.
The lower corners of the lid on my Acer Spin 714 Chromebook are very sharp and have made some deep scratches in my wooden tables. These low-profile bumpers prevent scratching surfaces and do not interfere with the laptop's hinge…
This replaces the original BentoBox duct to fit the Official Prusa MINI Enclosure. Compatible with the rest of the BentoBox v2.0 parts. Printing Print the duct in the default orientation (standing up). Print the mounting plate laying flat…
This holder allows you to attach the included brush/clean out tool to the handle of the Greenworks 22" 80v Snow Blower. My snow blower came with 2 extra self-tapping screws (pictured), so I designed this to use one of those. I also…
All you need is: A generic 17mm ball-mount magsafe magnet (something like this: https://www.aliexpress.us/item/3256806354307392.html ) A tripod with standard consumer 1/4"-20 threads I printed this slowly (40mm/s outer walls) in PETG and…
These are all currently available results.
